NOTE:
Steam and boiling water will come out of the soleplate, impurities and flakes will be flushed out.
Do not push and hold the self clean button while ironing.
Chapter 2.7 - Auto Shut Off Function
The
When the LCD panel shows PAUSE status and the buzzer start beeping, the backlight will turn to RED, the iron has been switched off by the
To let the iron heat up again:
Pick up the iron or move it slightly. The LCD panel shows originally status.
If the temperature of the soleplate has dropped below the set ironing temperature, the LCD panel will show heating up.
If the iron need heat up after you have moved the iron, until it reached required temperature before you start ironing.
If the iron does not require to heat up after you move it, but still indicates setting mode, the iron can be used.
When
Chapter 3: Maintenance and Cleaning
To prevent any risk of burns, all maintenance and cleaning operations should only be carried out when the unplugged appliance has cooled down for at least 2 hours.
Before cleaning, set the steam control knob to the “0” or “ 
”, unplug the iron from wall socket, and allow the appliance to completely cool down, and then clean with a damp cloth, do not immerse the unit into water or other liquids.
Clean and empty the water tank after every use.
If ironing clothes with high temperature, which is not recommended on the garment table, this will cause burns to your clothes and residue left on the soleplate of the unit, it is recommended that you iron over an old cloth to remove any residue from the soleplate.
After use, set the steam control knob to the “0” or “ 
”, disconnect the unit from mains socket, empty remaining water from water tank and then store the iron after it has been completely cooled down.
Never use scouring pads, abrasive or chemical cleaners, or solvents
8