Rowenta DZ5020 manual Stain the linen

None or too	Steam control set on	Turn the steam control to the
little steam is	dry position .	required setting area.
being emitted.
	Not enough water in	Fill the water tank.
	the water tank.
	Anti-Drip* is active	Wait for the soleplate to reach
	(§ 11).	the correct temperature.
Brown streaks	Residues in the steam	Use the Self Clean function then
come through	chamber or on the	clean your iron.
the holes inthe	soleplate.
soleplate and
	Use of chemical	Do not add any descaling agents
stain the linen.
	descaling agents.	to the water in the water tank.
		Use the Self Clean function and
		clean your iron.
	Fabric fibres have	Clean the soleplate with a
	accumulated in the	non-metallic sponge.
	holes of the soleplate	Vacuum the holes of the
	and are burning.	soleplate from time to time.
	Your linen is not rinsed	Ensure linen is rinsed thoroughly
	sufficiently or you have	to remove any soap deposits or
	ironed a new garment	chemicals on new garments
	before washing it.	which may be sucked by the
		iron.
	Use of starch.	Always spray starch onto the
		reverse side of the fabric to be
		ironed and clean your iron
		soleplate.
	Pure distilled /	Only use untreated tap water or
	demine-ralised or	mix half tap water with half
	softened water is	distilled/demineralised water.
	being used.	Use the Self Clean function and
		clean your iron.
Iron is leaking.	Overuse of shot of	Allow more time between each
	steam button.	shot.
	Soleplate temperature	Set the temperature control to a
	too low .	higher temperature.

If you are unable to trace the cause of the fault, contact an official Rowenta Customer Service Centre. The addresses are shown in the enclosed service centre address list. Helplines listed at the front of this leaflet.

Further hints and tips are obtainable from our homepage: www.rowenta.com. Subject to modifications !

* depending on model 10