Rowenta 1DM 900 manual Before USE, Starting UP, Steam Ironing, Adding water

Page 2

EAn electrical appliance is not a toy. Use and store the appliance out of reach of children. Do not let the supply cord hang down.

EDo not leave the appliance unattended while it is connected to the mains supply.

EElectrical appliances generate high temperatures. Always use the handles provided and warn other users of the potential dangers (e.g. escaping steam or hot water, especially when ironing vertically).

ENever treat clothing which is being worn.

EAlways disconnect the appliance:

before filling or emptying the water tank;

before leaving the room (even for a short time);

after use.

ENever unplug the appliance by tugging on the cord.

EOnly safe extension leads should be used.

EDo not immerse the appliance in water.

EAn electrical appliance should not be used if:

the appliance, the supply cord or the cord protector is damaged;

the appliance has been dropped;

the appliance is obviously leaking. In this case the appliance should be returned to an approved Rowenta Service Dealer for repair. (See enclosed list for addresses.)

ERepairs to electrical appliances may only be carried out by specialists. Improperly carried out repairs can cause serious danger to users. To avoid danger to users, a defective or damaged supply cord may only be replaced by an authorised Rowenta service centre.

ERowenta accepts no liability for damage arising from improper use or operation (see also POINTS TO NOTE). This appliance is for domestic use only.

PWhen the appliance has reached the end of its operational life it should be disposed of through the correct channels.

BEFORE USE

Remove the transparent soleplate protector

1Electronic 3-stage automatic switch-off (depending on model)

If the iron is switched on and not moved for a period of 8 minutes while standing on its heel or 30 seconds while standing on the soleplate or Iying on its side,

an internal safety feature will switch the iron off and the automatic switch-off indicator will blink. Move the appliance sharply to switch it on again.

STARTING UP

Please read the information under POINTS TO NOTE.

When using the iron for the first time, plug it into the mains electricity supply, set the temperature control to max., do not add any water, stand the iron on its heel and allow it to heat up in the vertical position for 2 minutes. A small amount of smoke may be generated. This is perfectly normal and will disap- pear after a short period of use.

STEAM IRONING

2Adding water

Unplug the iron.

Push the steam control slide fully to the left to shut off the steam valve (Position “min“).

Open the water filling inlet cover.

Hold the appliance upright so that the water inlet is horizontal.

Fill with water (containing no additives) to the max. water level mark and close the lid.

2

Image 2
Contents For appliance description see diagram on How to connect the cord to a U.K. plugSteam Ironing Before USEStarting UP Adding waterSpray Function Selecting the Ironing TemperatureAdjustable Steam Function Shot of SteamAfter Ironing Cleaning and MaintenanceDRY Ironing Always remember SERVICE/SPARE PartsPoints to Note