RN40854MUK Rev1_Instruction Booklet 15/09/2010 16:20 Page 5
FILLING A
1Make sure that the iron is not
plugged in, then set the steam dial ‹ to ‘O’ position D before filling the iron with water.
2Lift the filler cap › until it locks and holds in the open position.
Fill water through the filling hole into the water tank ‚, using a suitable container A.
A
The tank holds 350ml of water. The iron is fitted with a clear view water tank, so you can easily see the water level when filling. During filling, tilt the iron forward to read the water level. The ‘MAX’ mark is printed on
the side of the clear view tank B.
B |
MAX level mark |
After filling, push the filler cap forward until it clicks in place.
IN HARD WATER AREAS, THE USE OF DISTILLED OR DEMINERALISED WATER IS RECOMMENDED.
Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refrigerator.
3Always pour out the remaining water after use.
WARNING: When filling your iron with tap water, always use a suitable container. Never fill directly under the tap.
TEMPERATURE
CONTROL C
C
1Plug in the iron and switch on the power at the mains socket.
2Set the temperature dial ‡ to the temperature required C, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting.
•Your Morphy Richards iron is
fitted with a temperature indicator light · which will switch on and off whilst you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen.
•It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you will save time and energy.
For details of other Morphy Richards products, please see our website: | 5 |
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|