Morphy Richards 40652 manual Filling a, Features of Your a Iron

40652 rev1 23/4/08 17:52 Page 5

FILLING A

1 Make sure that the iron is not

plugged in and then set the

variable steam control ‹ to the

‘0’ position before filling the iron

with water.

2 Open the fill cap and pour water

through the filling hole › into

the water tank ·, using the

beaker provided, one beaker full

of water fills the tank (400ml). A

After filling, replace the fill cap.

In hard water areas, the use of

FEATURES OF YOUR A

IRON

Temperature indicator light

The indicator light under the control knob shows that the iron is warming up. When the required temperature is reached, the light will go out and will cycle on-off during operation.

distilled or demineralised water

is recommended.

Never use battery topping up

fluid or water containing any

substances like starch, or sugar,

or defrosted water from a

refrigerator.

3 Always pour out the remaining

water after use.

Warning: When filling your iron

with tap water, always use the

beaker provided. Never fill

directly under the tap.

Temperature control B

Plug in the iron and switch on. The ‘power on’ indicator lights „, situated in the back cover, will illuminate. Set the temperature control dial B to the temperature required, but don’t start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting.

Dry ironing

You can use your iron as a dry iron only. Make sure the variable steam control ‹ is set to the ‘0’ symbol.

Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see ‘Filling’ section).You do not need to put any water in the tank when dry ironing only.

Spray C

Press the spray button ¤ and aim the spray of water at stubborn creases.You can do this whilst dry ironing, providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed.

Variable steam D

B

W	l	Silk
oo			N
			yl
			on

C ott on

Linen Max

Min

C

Your Morphy Richards iron is fitted with an indicator light ‡ which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen.

It is always a good idea to begin with cool fabrics and work up to higher settings.

An iron heats up quicker than it cools down so you’ll save time and electricity.

Fill the iron with water as described in ‘Filling’, and insert the plug into the electrical socket.

The steam output can be varied from low to high by sliding the variable steam control D. When using the iron at the bottom of the steam range, the steam output should be adjusted to the lowest setting.

The steam facility should only be used on garments which are suitable for ironing within the steam band.

Steam uses additional energy. To save energy, only use steam when necessary.

D

lower	higher
steam	steam
2 dot	3 dot

5