GE WWSR3130 Possible Causes What To Do SensorWash indicator, Light on some models, About washer

Safety Instructions

Operating Instructions

Troubleshooting Tips

Customer Service

Before you call for service…

Troubleshooting Tips

Save time and money! Review the charts on the following pages first and you may not need to call for service.

SENSORWASH	Possible Causes	What To Do
SensorWash indicator	Washer is NOT in a wash fill	• This is normal. Light only illuminates during wash fills
light (on some models)	cycle or a warm rinse fill cycle	and warm rinse fills.
is not illuminated
SensorWash wash	The washer is in a cold rinse cycle	• This is normal. The SensorWash feature is designed not
temperature is incorrect		to activate during a cold rinse cycle so that the coldest
		water available is used.
(Review SensorWash	All the water in the water heater	• Wait until the water in the water heater is heated to the
in the About washer	has been used	correct temperature.
features section)

WATER	Possible Causes	What To Do
Too many suds	Type of detergent	• Switch to a lower sudsing detergent brand and follow
		instructions on package.
	Very soft water	• Try less detergent.
	Too much detergent.	• Measure your detergent carefully. Use less soap if you
		have soft water, a smaller load, or a lightly soiled load.
Water leaks	Fill hoses or drain hose is	• Make sure hose connections are tight at faucets and make
	improperly connected	sure end of drain hose is correctly inserted in and secured
		to drain facility.
	Household drain may	• Check household plumbing. You may need to call a
	be clogged	plumber.
	Constant water pressure	• Tighten hoses at the faucets and turn the water off after
	to the fill hoses at the	each use.
	water source	• Check condition of the fill hoses; they may need
		replacement after 5 years.
	Using too much detergent	• Use less detergent. Use less soap if you have soft water, a
	in washer	smaller load, or a lightly soiled load.
Water temperature	Control is not set properly	• Check water temperature control and adjust.
is incorrect
	Water supply is turned off	• Turn both hot and cold faucets fully on and make sure
	or improperly connected	hoses are connected to correct faucets.
	Water valve screens are	• Turn off the water source and remove the water connection
	stopped up	hoses from the upper back of the washer. Use a brush or
		toothpick to clean the screens in the machine. Reconnect
		the hoses and turn the water back on.
	House water heater is	• Make sure house water heater is delivering water
	not set properly	at 120°F.–140°F.(48°C.–60°C.).
Water won’t drain	Drain hose is kinked or	• Straighten drain hose and make sure washer is not sitting
	improperly connected	on it.
		• Top of drain outlet should be less than 8 ft. above floor.

12