Continental CP43021 Eléctricas Especificaciones, Mantenimiento y Cuidado, Prácticos Consejos

Page 6

preheated at least 1-2 minutes. If water still drips, turn the Temperature Dial to a slightly higher temperature setting.

Tips:

To avoid damage to fabrics, refer to the garment label for the fiber content and set the Temperature Dial to the lowest temperature setting recommended for the fabric. Always test a small, inconspicuous area on the garment before continuing to iron. If unsure of the temperature setting for a fabric, begin at the lowest temperature setting and gradually increase the setting until the desired ironing effect is achieved. When possible, use a press cloth or turn fabrics inside out to help prevent damage.

CAUTION: Fabrics requiring a temperature setting below the “WOOL” setting cannot be steam pressed.

Begin ironing with those garments/fabrics that require a low temperature setting (e.g., silk) followed by those requiring a high temperature setting (e.g., wool, cotton, linen).

Use care when ironing around plastic buttons or zippers, as these items may melt from the heat of the product. A press cloth is recommended to prevent damage to the items and to the Soleplate of the product.

Care and Maintenance

WARNING: Turn the Temperature Dial to the “0” (Off) position, unplug the product from the electrical outlet, and allow the product to cool completely before cleaning it.

CAUTION: Do not use abrasive cleaners/pads, steam iron cleaners, or vinegar to clean the product any part of the product.

Wipe the outside and the Soleplate of the product with a damp cloth.

Drain the product by turning the Soleplate away from you and carefully turning the product upside down over a sink; allow any remaining moisture inside of the product to evaporate before storing.

WARNING: Even if the Soleplate is cool, use caution when draining the water from the reservoir, as it may still be hot.

Electrical Specifications

Voltage

Frequency

Wattage

Amperage

120 VAC

60 Hz

1000W

8.3 A

 

 

 

 

A 3.8

100W

 

Hz 60

AC 120V

Amperaje

Vatios

 

Frecuencia

Voltaje

 

 

 

eléctricas Especificaciones

.caliente algo estar aún podría que y tanque del agua el drenar de mento

-mo al cuidado tenga fría, ya encontrara se base la cuando Aún ADVERTENCIA:

.guardarlo de antes evapore se electrodoméstico del dentro humedad

la de resto el que Deje .lavadero un sobre cabeza de plancha la voltee cuidado con

y usted de contrario lado el hacia base la colocando electrodoméstico el Drene •

 

.húmedo paño un con producto del base la y exterior el Limpie •

.piezas sus de ninguna ni electrodoméstico el limpiar para vinagre o vapor a chas

-plan para limpiadores esponjas, o abrasivos limpiadores utilice No PRECAUCIÓN:

 

 

 

.limpieza la con proceder de antes

completamente

enfriar dejándolo electrodoméstico desenchufar a proceda y do)

-apaga – (OFF “0” posición la en temperatura de perilla la Coloque ADVERTENCIA:

 

 

 

mantenimiento y Cuidado

 

 

 

.plancha la de base la proteger vez la a

y artículos estos dañar evitar para planchar para paño un utilizar recomienda Se .co

-electrodomésti el por emitido calor al debido derretirse pueden éstos que ya cierres

de o plásticos botones de zonas las de alrededor planchar al cuidado Tenga •

 

.lino) algodón, lana, ejemplo, (por alto más temperatura

de nivel un requieran que aquellas con continúe luego y seda) ejemplo, (por menor

temperatura de nivel un requieran que telas o prendas las planchando Comience •

 

 

 

.vapor a plancharse pueden no “LANA”,

de al menor temperatura de nivel un requieran que telas Las PRECAUCIÓN:

 

.daños evitar para revés al prendas las voltee o planchar

para paño un utilice posible, lo de Dentro .deseado efecto el alcanzar hasta nivel el

incremente gradualmente y bajo más nivel al planchando comience tela, de tipo un

para temperatura de nivel del seguro está se no Si .planchando continuar de antes

visible no y pequeña prenda o tela la de zona una con pruebe Siempre .tela dicha

para recomendado bajo más nivel al temperatura de perilla la coloque y fibras las

de contenidos los ver para etiquetas las verifique telas, las dañar no de fin el Con •

 

 

 

prácticos: Consejos

 

 

.alto más ligeramente temperatura de nivel un

a temperatura de perilla la gire agua, goteara aún Si .minutos 2 a 1 de menos lo por

precalentado haya se electrodoméstico el que y Lino) - (Lana vapor a planchado de

rango del dentro encuentre se temperatura de perilla la que de asegúrese vapor,

de aberturas las de través a agua goteara Si .veces dos o una planchar de tabla

la sobre base la poco un golpee cuidado con planchado, de horizontal posición

en y caliente encuentra se electrodoméstico el y vapor a planchado de opción la

en correspondiente botón el colocando vapor produjera se no Si Importante:

.guardarlo o trasladarlo de antes completamente enfríe

Image 6
Contents Vapor de Plancha Steam DryIron Usar DE Antes Instrucciones LAS Todas LEA Importantes PrecaucionesAgua el en mano su sumerja ni toque No Futuro EL Instrucciones Estas GuardeParts Before First Use Uso primer del AntesDry Pressing Eléctricas Especificaciones Mantenimiento y CuidadoPrácticos Consejos

CP43021 specifications

The Continental CP43021 is a high-quality tire designed to meet the demands of various driving conditions while ensuring safety, performance, and comfort. Specifically engineered for cars and light trucks, this tire demonstrates Continental's commitment to innovation and excellence in tire technology.

One of the key features of the CP43021 is its advanced tread design, which enhances traction on both wet and dry surfaces. The tire incorporates a unique pattern that promotes precise handling and stability, allowing drivers to navigate corners with confidence. Its shoulder blocks are strategically placed to improve grip and provide better control during turns, making it an ideal choice for performance-oriented vehicles.

The CP43021 is also built with Continental's proprietary Silica Compound, which contributes to improved fuel efficiency. This innovative material not only reduces rolling resistance but also enhances the tire's overall durability. Drivers can expect a longer tread life, translating to fewer replacements and lower long-term costs.

Another noteworthy characteristic of the CP43021 is its noise-reducing technology. The tire is designed to minimize road noise, creating a quieter ride for both the driver and passengers. This feature is particularly beneficial for those who spend long hours on the road, as it enhances overall comfort and reduces fatigue.

Safety is paramount in the design of the CP43021. The tire features reinforced sidewalls that provide additional protection against impact damage, which is crucial for maintaining structural integrity during low-speed maneuvers or encounters with obstacles. Furthermore, the tire incorporates improved wet braking capabilities, ensuring that drivers can stop safely and effectively in rainy conditions.

The CP43021's performance in various weather conditions is also impressive. It’s suitable for year-round use, and thanks to its versatile design, it handles light snow without compromising on handling or performance. This adaptability makes it an excellent option for drivers in regions with varying climates.

In summary, the Continental CP43021 embodies a blend of advanced technology, safety features, and performance capabilities. Its innovative tread design, Silica Compound, noise-reducing technology, and robust construction make it a dependable choice for drivers seeking quality and reliability in their tires. Whether navigating city streets or embarking on longer journeys, the CP43021 stands out as a solid option for a diverse range of vehicles.