•The
•The light cycle glows on and off during ironing.
3.When finished ironing, unplug the iron and place it on its heel rest.
4.Move the dry/steam selector to .
10-MINUTE AUTO SHUTOFF
For your peace of mind, the iron will turn off after 10 minutes of inactivity.
• The iron beeps and the auto shutoff light starts blinking to let you know that the iron has stopped heating (F).
• As soon as you pick up the iron, it starts heating again.
F
SURGE OF STEAM
1.With the water tank filled to the MAX mark, turn the
2.To remove tough wrinkles, pump the button at
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service personnel.
CLEANING OUTSIDE SURFACES
1.Make sure iron is unplugged and has cooled completely. Wipe the soleplate and outer surfaces with a soft cloth dampened with water and mild household detergent. Never use abrasives,
2.After cleaning, steam iron over an old cloth to remove any residue from the steam vents.
SELF-CLEANING
To keep the steam vents free of any buildup, follow these instructions about once a month.
1. | Fill the water tank below the MAX line. |
2. | Plug in the iron. |
3. | Turn the |
|
Vertical steam
4. Unplug the iron and hold over a sink with the soleplate facing down. |
1.Hang the garment to be steamed on a clothes hanger. (Curtains or drapes can be steamed once they are hung.)
2.Move the selector to .
3.Hold the iron close to, but not touching, the fabric.
4.Pull the fabric tight with your free hand and pump the button as you move the iron over the fabric (G).
K |
5.Move the dry/steam selector to . Be careful, as hot water and steam will come out of the steam vents (K). Continue to hold the
selector in the position until all the water has emptied, or until you feel all mineral deposits have been flushed. If necessary, rock iron side to side and front to back.
SPRAY
You can use spray at any setting. Check that the water tank is filled with water.
1. Press the button (H).
H | 2. If spray is weak, pump the button a few times. |
EMPTYING WATER TANK AFTER IRONING (OPTIONAL)
1. Unplug the iron and let it cool.
2. Open the
| 3. To release the water, hold the iron over a sink with the tip pointing |
J | down and to one side. Water will empty out of the |
| opening (J). |
6.When finished, release the selector, stand the iron on its heel rest and plug it in. Heat for about 2 minutes to dry out any remaining water.
STORING YOUR IRON
1.Unplug the iron and allow it to cool.
2.Check that the selector is set to .
3.Store vertically on its heel rest to prevent water leaking from the soleplate.
5 | 6 |