Tricity Bendix WDR 1030 Levelling, Special conditions, Interest of the environment

Levelling

Level the washer-dryer by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable.

P1051

Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation.

Some vibration is inevitable, especially if mounted on a wooden floor.

Sprung wooden floors are particularly susceptible to vibration. For advice, consult a builder. If possible, always place the machine on a solid floor.

Special conditions

If the floor is carpeted or covered with crumbly or soft material, insert a rigid support base under the feet to prevent noise, vibration or displacement. The base should protrude a few centimetres beyond the edges of the machine.

Warning

The machine should NOT be placed on deep pile carpeting.

Note

Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown.

In the interest of the environment

Washer-dryers and dishwashers should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.

It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.

If you require any further advice please contact your local water authority.

SHOWER
	SINK	TOILET
BATH		BIDET
WASHING	DISHWASHER
MACHINE
RAINWATER
'RUN-OFF'
		FOUL DRAIN
SURFACE WATER		FOUL SEWERS
DRAINS & SEWERS
		SEWAGE
UNTREATED		TREATMENT
DISCHARGE		WORKS
		TREATED
		DISCHARGE
RIVER		RIVER
P0987

29