Tricity Bendix AW 1001 W installation instructions Control Panel

Page 6

The Control Panel

1 Detergent dispenser drawer

Programme Option buttons

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before pressing the “start pause” button.

When these buttons are pressed, the corresponding pilot lights come on. When they are pressed again, the pilot lights go out.

If an incorrect option is selected, the corresponding pilot light flashes for about 2 seconds.

2 Spin reduction/no spin button

By pressing this button you can reduce the final and the intermediate spin speeds or select the “no spin” option:

“spin reduction”: by selecting this option the speed will be reduced as follows:

Cotton: from 1000 to 500 r.p.m.

Synthetics and wool: from 900 to 450 r.p.m.

Delicates: from 700 to 450 r.p.m.

“no spin”: by selecting this option all the spinning phases are suppressed. To be used for extremely delicate items.

The machine will add 3 rinses on cotton programmes and 1 rinse on synthetic programmes.

4 Half Load button

Select this button to reduce water consumption on the rinse cycle when washing a smaller load of cottons or linens (maximum load size = 2.25 kg).

The machine will perform 2 rinses instead of 3.

5 Rinse Hold button

When selecting this option the water of the last rinse is not emptied out, to prevent the fabrics from creasing. At the end of the programme the pilot lights “door” and “end” illuminate. To drain water, proceed as follows:

turn the programme selector dial to position “O”;

select programme 14 (drain) or 15 (spin). In this case reduce the spin speed by means of the relevant button to adapt it to the fabrics to be spun.

press “start pause” button.

6 Start Pause button

After having selected the required programme, press this button to start the machine; the corresponding pilot light stops flashing turning on constantly.

To interrupt a programme which is running, press the “start pause” button: the corresponding pilot light starts to flash.

To restart the programme from the point at which it was interrupted, press the “start pause” button again.

3 Prewash button

Select this option if you wish your laundry to be prewashed before the main wash (not available for wool). The prewash ends with a short spin in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained.

7 Programme progress display

By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on.

6

Image 6
Contents AW 1001 W Installation Child SafetyUse Contents Your New Washing Machine Ecological hintsDescription of the Appliance Detergent dispenser drawerPrewash Main wash Fabric softener Control Panel Programme selector dial Programme informationLoad the laundry Operating SequenceSelect the required programme Select spin reduction or no spin optionAltering a programme Cancelling a programmeStart the programme Interrupting a programmeMeasure out the detergent Measure out the fabric softenerAt the end Programme Washing Hints 1000g = 1 kgWhich detergent? Which form?Wash Care Symbols Important NotesWashing symbol Type of laundry Dial position Washing ProgrammesLoad Washing symbol Type of laundry Options LoadMaintenance and Cleaning Cleaning the water inlet filter Emergency emptying outSomething Not Working Service & Spare Parts 0870 5European guarantee Guarantee ConditionsStandard guarantee conditions Customer CareInstallation Instructions Technical SpecificationsUnpacking Installation on a Suspended FloorInstall the machine on a flat hard floor PositioningAppliance must be connected to a cold water supply Water inletWater drainage Into a drainage standpipeOnto a sink outlet spigot LevellingSpecial conditions Entering the washing machinePermanent connection Interest of the environmentElectrical connection Blue- Neutral Brown- LivePage Consumer care telephone number 08705 950