Operating sequence
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a time, shaking them out
as much as possible. Close the door.
2.Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment 
and, if you wish to carry out a programme with the prewash phase, pour it into the
compartment marked 
.
If required, pour fabric softener into the
compartment marked 
(the amount used must not exceed the «MAX» mark in the drawer). Close the drawer gently.
3. Select the required programme
The selector dial is divided into following sections:
● Cottons,
● Synthetics,
● Special
The green Start/Pause light starts to flash. The selector dial can be turned either clockwise or anticlockwise.
Position «Off» to Reset programme/Switching OFF of the machine.
At the end of the programme the selector dial must be turned to position «Off», to switch the machine off.
IMPORTANT!
If you turn the programme selector dial to another programme when the machine is working, the red Start/Pause pilot light will flash 3 times to indicate a wrong selection. The machine will not perform the new selected programme.
4.Select the spin speed or Rinse Hold option
Press the Spin button repeatedly to change the spin speed, if you want your laundry to be spun at a speed different from the one proposed by the appliance.
The relevant light will light up. Maximum speeds are:
●Cottons: 1200 rpm for AW1202W and 1400 rpm for AW1402W
●Synthetics, Wool, Handwash, and Sport 900 rpm
●Delicates 700 rpm;
Rinse Hold 
: by selecting this option the water of the last rinse is not emptied out to prevent the fabrics from creasing. When the programme has finished the pilot lights «Door» and «End» are alight, the Start/Pause and «Wash» lights are off and the door is locked to indicate that the water must be emptied out.
To empty out the water:
1.turn the programme selector dial to «Off» 2.select the Drain or Spin programme 3.reduce the spin speed if needed, by means of
the relevant button 4.depress Start/Pause button
5.at the end of programme, only the pilot lights End comes on.
13