Tricity Bendix AW1002 W user manual Water inlet, Water drainage, Into a drainage standpipe

Page 24

126.2942.00…AW1002W.qxd 29/11/07 19:00 Página 24

Water inlet

There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4" for the water supply, a sink, a wash basin or a drainage system in the wall.

Previously check if:

-it is not a hot water tap.

-the running water is clean. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Have the permanent drainage system in the wall checked by a plumber.

1.Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.

NOTE

Installation should comply with local water authority and building regulations’ requirements.

2.If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. Now tighten the nut anew to avoid leaks. (Open the tap and assure that it does not leak and close it again.)

The appliance must be connected to a cold water supply.

A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum distance of 5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Water drainage

This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods.

1. Into a drainage standpipe.

U” piece supplied

Firstly form a hook in the end of the drain hose using the «U» piece supplied. Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring there is an air break between the drain hose and standpipe.

When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.

24

Image 24
Contents User Manual Washing Machine Content Thank you for selecting our applianceSafety information General safetyInstallation Child safety UseDescription of the appliance Detergent dispenser drawerProgramme selector temperature allows to select a Control panel and functionsProgramme/ Temperature Programme tableType of laundry OptionsProgramme/ Temperature Type of laundry Description Options Wool HandwashMini 30’ Silk Sport Shoes Rinse Drain SpinProgramme information Washing hints Detergents and additives Before the first use Quantity of detergent to be usedDegrees of water hardness Operating sequence Select Prewash, Intensive, Super Quick option Select the Extra Rinse optionSelect the Start/Pause Cancelling a programme Altering an option or a running programmeInterrupting a programme Opening the door after the programme has startedCare and cleaning Emergency emptying out Malfunction Possible Cause / Solution Something not workingWater tap is closed. Red Start/Pause pilot light flashes Red Start/Pause pilot light flashesMalfunction Red Start/ Pause pilot light flashesMod Technical data Consumption values Programme Duration MinutesEnergy Consumption KWh Water Litres InfosInstallation instruction Transit security barsMake sure the hoses are not squashed PositioningWater inlet Water drainageInto a drainage standpipe Onto a sink outlet spigot Special conditionsInterest of the environment Electrical connection Permanent connectionEnvironmental concerns Packaging materialsOld machine Ecological hintsGuarantee conditions European guarantee 126.2942.00…AW1002W.qxd 29/11/07 1900 Página 126.2942.00…AW1002W.qxd 29/11/07 1900 Página 126 2942 Subject to change without notice