Reliable i30, I60 instruction manual Troubleshooting, Problem

TROUBLESHOOTING:

PROBLEM

Does the steam iron leak steam mixed with water?

There is no steam coming out of the iron?

Does the steam leak dirty water?

How to clean the boilers i700-i702

How to clean the boiler i300-i500

EXPLANATION		SOLUTION
1) While filling the tank you	1)	The problem will go on until the
may have poured too much	excess water		is emptied. Keep the
water into the tank.	steam button depressed until the
	water in the tank is at the correct
	level.
2) The iron plate has to be hot	2)	Please check that the temperature
enough to produce dry steam.	knob is on the right position: “cotton
	°°°”
1) The steam knob (where	1)	Open	the	steam	knob
supplied) might be closed.	anticlockwise.

2)The iron switch might be off. 2) After the iron switch comes on, wait for 4 minutes so that the iron

3) The boiler switch might be	plate gets hot.
off.	3) After	the boiler switch comes on,
	wait for	10-20 minutes so the boiler

4)The water might be used up. produces steam.

4)Fill it following the instructions carefully.

Some dirty water might have	Fill the empty tank with water
gone into the boiler with the	(i300/i500), screw the cap tight,
water and it is given off from	shake it, unscrew the cap and empty
the iron.	the tank. Repeat the action	until	the
	water is cleaned. We	do	not

recommend the use of any additive to pour in the tank. Before ironing again spray some steam on a cloth until clean steam comes out.

Clean the boiler frequently by opening the exhaust valve but only when the boiler has been disconnected from the electrical outlet – let pressure go down first.

The use of normal tap water is recommended. In order to clean the boiler and remove limestone, rinse it internally (every 15-20 litres of water used or every month) with tap water.