Sunbeam SR6900 manual Using the shot of steam, Using the spray mist, way safety auto-off feature

Page 9

Using your Sunbeam Accura® Iron (continued)

Using the shot of steam

The shot of steam can be used when dry or steam ironing.

1.Ensure that the tank is at least ¼ full of water.

2.Select the desired temperature using the +/- buttons.

Note: The Accura iron’s twin element construction allows you to iron with maximum steam, even on low temperature settings.

3.Press the shot of steam button several times with the iron on the soleplate to prime the pump.

Note: If the water tank has run dry, it may be necessary to re-prime the pump after filling the iron with water.

Using the spray mist

The spray mist can be used when steam or dry ironing to pre-dampen hard to iron fabrics.

1.Ensure that the tank is at least ¼ full of water.

2.Press the spray button during ironing to release a fine mist from the spray nozzle.

The 3 way safety auto-off feature

For total safety and peace of mind, the iron will automatically switch itself off if left unattended. It will switch off if left in the ironing position for 30 seconds, or if it is knocked onto its side. It will also switch off if left unattended in the upright position for 15 minutes.

15 mins

30 seconds

Should you leave the iron unattended, the red light located between the +/- temperature buttons will flash and a warning beep will sound to alert you that the auto-off function has been activated. ‘Standby’ will appear on the LCD screen.

Figure 6

Power to the iron’s heating element will be cut and the iron will start to cool.

To reset the safety auto-off feature, simply move the iron. The power to the iron’s elements will then reconnect and it will begin heating again. Wait until the green light illuminates before recommencing ironing.

After 30 seconds the frequency of the beep alarm will decrease.

Abnormal digital function

If you find that your iron is incapable of steaming or that the temperature control buttons have become inoperable, a fault has occurred. In the event of a fault, the red temperature alert light located between the +/- temperature buttons will flash. To reset the iron, simply switch it off at the power outlet. The iron can then be switched on again and should operate normally. If the fault persists contact the Sunbeam Consumer Service line.

Figure 5

9

Image 9
Contents Accura Digital Resilium Important instructions retain for future use ContentsSunbeam’s Safety Precautions For examination, repair or adjustmentEnsure the above safety precautions are understood About Accura Accura Digital ResiliumFeatures of your Sunbeam Accura Iron Maximum water level indicator Way safety auto offRemovable steam valve Water inlet coverLCD screen Long 3 metre cord with 360 cord outletExtra large 400ml water tank Anti calcUsing your iron Using your Sunbeam Accura IronBefore first use Filling the iron with waterUsing the spray mist Using the shot of steam3 way safety auto-off feature Abnormal digital functionIroning Guide Care and CleaningIroning Chart Nylon & PolyesterDenim Use maximum steam New Zealand Australia