Cannon IWC manual Control panel, ON/OFF button, Detergent dispenser drawer

Description of the washing machine and starting a wash cycle

GB

Control panel

ON/OFF button

WASH CYCLE PROGRESS/

DELAY TIMER indicator lights

FUNCTION	START/PAUSE
buttons with
	button with
indicator lights
	indicator light

Detergent dispenser drawer

WASH CYCLE

knob

Detergent dispenser drawer: used to dispense detergents and washing additives (see “Detergents and laundry”).

ON/OFF button: switches the washing machine on and off.

WASH CYCLE knob: programmes the wash cycles. Du- ring the wash cycle, the knob does not move.

FUNCTION buttons with indicator light: used to select the available functions. The indicator light corresponding to the selected function will remain lit.

TEMPERATURE knob: sets the temperature or the cold wash cycle (see “Personalisation”).

SPIN SPEED knob: sets the spin speed or exclude the spin cycle completely (see “Personalisation”).

WASH CYCLE PROGRESS/DELAY TIMER indicator lights: used to monitor the progress of the wash cycle. The illuminated indicator light shows which phase is in progress.

If the Delay Timer function has been set, the time remai- ning until the wash cycle starts will be indicated (see next page).

TEMPERATURE
		DOOR LOCKED
knob
SPIN SPEED		indicator light
	knob

DOOR LOCKED indicator light: indicates whether the door may be opened or not (see next page).

START/PAUSE button with indicator light: starts or tem- porarily interrupts the wash cycles.

N.B. To pause the wash cycle in progress, press this button; the corresponding indicator light will flash orange, while the indicator light for the current wash cycle phase will remain lit in a fixed manner. If the DOOR LOCKED indicator light is switched off, the door may be opened.

To start the wash cycle from the point at which it was inter- rupted, press this button again.

Standby mode

This washing machine, in compliance with new energy sa- ving regulations, is fitted with an automatic standby system which is enabled after about 30 minutes if no activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again.

6