Century PM-1634AB 6/01 manual FORWARD-FACING Installation

Page 10

FORWARD-FACING INSTALLATION

1

2

3

Adjust car seat to upright or semi-uprightposition and place forward-facingon vehicle seat.

Thread vehicle seat belt through openings and behind harness straps (fig. a).

Buckle belt.

Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt.

HINT: Use your knee to press down in center of car seat (fig. b).

4

5

Pull front to back and left to right to check for secure installation (fig. c). Vehicle lap belt MUST stay tight.

If not secure, see “Vehicle Seat Belts” section.

Attach tether strap hook (A) to anchor hardware (B) and tighten strap to remove any slack (fig. d).

If tether anchor hardware (B) is not available, see “Installation of Anchor Hardware“ section.

8

Image 10

Contents Avoid injury or death Read and understand this manual Table of Contents Important Information Registration InformationPage Page Basic Information Outgrowing Car Seat Height & Weight LimitsPreterm or Low Birth Weight Infants Rear-facingBirth to 30 lbs .6 kgREAR-FACING Installation Fig. a Fig. eFORWARD-FACING Installation Openings Pull to tighten Placing Child in CAR Seat Placing Child in CAR Seat Or Upright #4 position While pulling harness straps outBuckle Upper Lower For Infants or Small Toddlers For ToddlersBottom Loop Rear Recline Lever Fig. fVehicle Seat Belts Belts Forward of Seat Crease Seat CreaseLap Belts With Retractor Lap Belts Manually AdjustableFlip Passive Restraint Lap Belt with Motorized Shoulder Belt Passive Restraint Lap or Shoulder Belt Mounted on DoorCombination Lap/Shoulder Belt with Locking Latch Plate Combination Lap/Shoulder Belt with Sliding Latch PlatePull Locking Clip Installation of Anchor Hardware Additional InformationTether Storage Tether HookCare & Cleaning Removing Seat PadSeat Pad Aircraft UseSecond Hand Car Seat Harness StrapsCall US First