Electrical Connections

Note: we recommend you keep the transit bracket, braces and screws to immobilise the machine for future transit.

The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.

Water connection

The machine has an inlet hose with 3/4» threaded ferrules fitted to the ends to attach between the threaded connector on the appliance and the cold water supply.

The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be resused.

The appliance must only be connected to the cold water supply.

Connection to a warm water supply, that is over 40°C, may damage certain delicate fabrics.

min 4 cm

	cm	+2,6 mt max
	100	+2,6 mt max
	100
	max	min 50 cm
	max	max 85 cm

Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply.

For the washing machine to function properly the terminal end of the discharge hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground.

Washing machines are supplied to operate at a voltage of 230 V, 50 Hz single-phase. Check that the conductor is powerful enough to supply at least 3.0 kW, then connect the plug to a 10 A earthed socket.

After installation,the appliance must be positioned so that the plug is accessible. Check that the electricity supply to your home has an earthing system.

The socket in your home and the plug on the appliance must be of the same type. It is generally not advisable to use multiple adapters and/or extension leads.

All Candy washing machines comply with the safety requirements laid down by the Quality Trademark Institute.