First wash cycle, Connecting the drain hose

Connecting the drain hose

	! CAUTION: if this appliance is supplied from a cord	AUS
	extension set or electrical portable outlet device, the cord	AUS

65 - 100 cm

Connect the drain hose, without bending it, to a drain duct or a wall drain situated between 65 and 100 cm from the floor;

alternatively, placed it over the edge of a basin, sink or tub, fastening the duct supplied to the tap (see figure). The free end of the hose should not be underwater.

extension set or electrical portable outlet device

must be positioned so that it is not subject to splashing or

ingress of moisture.

!The cable should not be bent or compressed.

!The cable should be replaced only by authorised technicians.

!If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

Warning! The company shall not be held responsible in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the programme “Auto Clean” (see “Cleaning the washing machine”).

!We advise against the use of hose extensions; if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity socket, make sure that:

•the socket is earthed and complies with all applicable laws;

•the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table (see opposite);

•the power supply voltage falls within the values indicated in the Technical data table (see opposite);

•the socket is compatible with the plug of the washing machine. If this is not the case, replace the socket or the plug.

!The washing machine must not be installed outdoors, even in covered areas. It is extremely dangerous to leave the appliance exposed to rain, storms and other weather conditions.

!Once the machine has been installed, the electricity socket should be easily accessible.

!Avoid using any extension cord or multiple socket outlet.

Technical data

Model	WMF 729

	width 59.5 cm
Dimensions	height 85 cm
	depth 54 cm

Capacity	from 1 to 7 kg

Electrical	please refer to the technical data plate
connections	fixed to the machine

	maximum pressure 1 MPa (10 bar)
Water connections	minimum pressure 0.05 MPa (0.5 bar)
	drum capacity 52 litres

Spin speed	up to 1200 rotations per minute

Energy rated
programmes	program Cotton 5; temperature 40°C;
according to	1200 rpm, using a load of 7 kg.
AS/NZS 2040.2

This appliance conforms to the following EC Directives:

- 2004/108/EC (Electromagnetic Compa- tibility)

-2006/95/EC (Low Voltage)

-2012/19/EU