AEG W 1255 manual Creased Has been put in the drum Care fabrics, select

Operating Instructions

Problem	Possible cause	Remedy
		Pay attention to the maximum
Washing is heavily	Probably too much washing	load quantity (see Programme
		Tables). In the case of easy-
creased.	has been put in the drum.
		care fabrics, select the
		< (EASY IRON) programme.
The washing has	The washing was not able to	Always load the drum as ful as
not been spun as	be distributed evenly in the	possible with a combination of
dry as usual.	drum prior to spinning.	large and small items.
	The drain hose is kinked.	Remove the kink.
	The maximum pump height	Contact your local Service
Washing is not		Force Centre. For pumping
	(outlet height 1 m from
		heights over 1 m a conversion
thoroughly spun,	the base of the appliance)
		kit is available as a special ac-
water remains visi-	is exceeded.
		cessory.
ble in the drum.
The indicator		Switch off the machine and
L (END) flashes
	The drain pump is blocked.	disconnect the mains plug.
twice.
		Clean the drain pump.
	For siphon attachments:	Clean the siphon.
	the siphon is blocked.
		Wait until the programme has
		ended, the K (DOOR) light
The door cannot be		goes off and the L (END)
		light is lit.
opened when the
		If it is necessary to open the
washing machine	Door is locked due to high
is on.		door immediately,
	water level, or high tempera-
O/s (START/		Turn the programme selector
	ture.
PAUSE) and K		to I (OFF); then turn it to
(DOOR) lights come		v (DRAIN). Press the O/s
on.		(START/PAUSE) button.
		When the water has been
		pumped out, the door can be
		opened.

30