AEG 70330 manual Not been removed

		Operating Instructions
Problem	Possible Cause	Remedy
	The transport packaging has	Remove transport packaging
		according to the installation
	not been removed.
		and connection instructions.
	The height-adjustable screw	Adjust in accordance with
		the installation and connec-
	feet are not correctly set.
		tion instructions.
The washing machine	There is not much washing in	This does not impair the
vibrates during opera-
tion or it is on an une-	the drum (e.g. only one	function.
	dressing gown).
ven surface.
	The water could not be com-	Check the laying of the
		drainage hose and eliminate
	pletely pumped off before	the bend if necessary, or
	spinning because the drain-
		clean the solution pump and,
	age hose is bent
		if required, remove foreign
	or
		bodies from the pump
	the solution pump is blocked.
		housing.
The washing solution	Too much detergent was	Meter the detergent exactly
of the main wash		in accordance with the
	probably used.
froths up a lot.		manufacturer's information.
	The screw connection on the	Tighten the intake hose
	intake hose is leaky.	screw connection.
	The drainage hose is leaky.	Check the drainage hose and
		replace it if necessary.
	The washing solution pump	Close cover correctly.
	cover is not correctly closed.
Water runs out under	Washing stuck in the filling	Stop the program, remove
		washing from the door, start
the washing machine.	door.
		a new program.
		Shut the emergency drain
		hose off properly (see section
	The emergency drain hose is	"Carrying out emergency
	not properly shut off or it is	drainage"). Call your after-
	not water-tight.	sales service if the emer-
		gency drain hose is not wa-
		ter-tight.

31