WATER CONNECTION
For normal kitchen
Connect the inlet hose to the male hose thread adapter by turning it clockwise to be fixed tightly. Make sure to insert the rubber ring enclosed. Then connect tightly to your sink.
Note: Some faucets may require you to also use the female hose thread adapter between the male adapter and your sink faucet as shown below. Make sure the rubber ring is inserted and connect to your sink.
If water leaks from faucet connection or washer connection, turn off water and tighten fully using a wrench. Be careful not to over tighten and damage water connection. Turn on water supply and make sure no leaks are present.
DISCONNECTING THE INLET HOSE
Dismantling the hose directly may cause water to splash due to the possible high water pressure in the hose, even after the faucet has been turned off. Please take off the hose as per following steps, even if the faucet is closed:
? Turn off the faucet.
? Turn on the power and let the machine run for about 5 seconds then turn it off.
? Remove the connecting nuts from the faucet and washing machine.
CONNECTING
NUT
Note: If the washing machine is frequently used, it is not necessary to dismantle the inlet hose to avoid possible damage to the screws .
POSITIONING THE DRAIN HOSE
Connect the drain hose to the water outlet of the washing machine then fasten it with a pinchcork. Since only up drainage is available, drain hose can be hung in the basin or bathtub.
NOTE: The highest point of the drain hose must be in the height of 0.7
11