HOW TO USE YOUR NEW WASHER-DRYER
•Load the drum with clothes as previously described. Close the door.
•Select a program. See chart below.
•Select drying time (and half heat if required).
•Select desired spin speed (high spin only occurs in regular wash cycle).
•Put the detergent, bleach and fabric conditioner into the dispenser.
•Press the
Note: Woolen garments should under no circumstances be tumble dried.
TUMBLE-DRY
If you want to tumble dry a load without washing, rinsing or spinning, proceed as follows:
Note: The dry weight of the load must not exceed requirements previously mentioned.
•Make sure that the power cord is plugged in and that circuit is energized.
•Make sure that the wash timer knob is at an
•Press the Half Heat button, if you wish to dry at a low temperature.
•Set the Dryer Timer knob to the drying time you require.
•Open the door, load the articles to be dried into the cylinder and close the door.
•Press the ON/OFF button in and the machine will then start the drying cycle.
•Door may be opened during drying cycle.
TO RINSE, SPIN AND TUMBLE-DRY
It is possible to rinse, spin and
•Make sure that the power cord is plugged in and that the circuit is energized.
•Open the hot and cold water taps fully.
•Load the machine with the articles to be rinsed.
•If you wish, put fabric conditioner in the additives compartment "D" of the Detergent Dispenser.
•Turn the program selector knob to the position marked "Rinse". Select the desired heat setting. Press the half heat if you want a low dry temperature. Set the dryer timer to the desired time.
•Select the desired spin speed. High speed spin only occurs in the regular cycle.
•Switch the machine on by pressing the ON/OFF button.
WASHING TABLE
**Compartments may be used with the selections indicated.
*With the cycle C/C please proceed as follows.
COLD WASH
Add detergent in compartment "A"
PRE-WASH/COLD WASH
Add detergent in compartment "A" and Switch the machine on.
When the machine starts the
Page 10