Draining any remaining water and | by pulling out the plug at the end of the | |
cleaning the pump filter | hose. If the amount of water to be drained | |
Your product is equipped with a filter system | off is greater than the volume of the | |
container, replace the plug, pour the water | ||
which ensures a cleaner water discharge that | ||
out, then resume the draining process. | ||
extends pump life by preventing solid items | ||
• After draining process is completed, | ||
such as buttons, coins and fabric fibers from | ||
replace the plug into the end of the hose | ||
clogging the pump propeller during discharge | ||
and fit the hose back into its place. | ||
of the washing water. | ||
If your product is not supplied with an | ||
• If your machine fails to drain the water, | ||
emergency drain hose, do the following as | ||
the pump filter may be clogged. You may | ||
shown in the figure below: | ||
have to clean it every 2 years or whenever | ||
| ||
it is plugged. Water must be drained off to |
| |
clean the pump filter. |
| |
In addition, water may have to be drained off |
| |
completely in the following cases: |
|
•before transporting the machine (e.g. when moving house)
•when there is the danger of frost
In order to clean the dirty filter and discharge |
| |
the water; | • Place a large container in front of the filter | |
1- Unplug the machine to cut off the supply | ||
to receive water flowing from the filter. | ||
power. | ||
• Loosen pump filter (anticlockwise) until | ||
AThere may be water at 90°C in the | ||
machine. Therefore, the filter must be | water starts to flow out of it. Direct the | |
flowing water into the container you have | ||
cleaned only after the inside water is | ||
placed in front of the filter. You can use a | ||
cooled down to avoid hazard of scalding. | ||
piece of cloth to absorb any spilled water. | ||
2- Open the filter cap. The filter cap may be | ||
• When there is no water left, turn the pump | ||
composed of one or two pieces according to | ||
filter until it is completely loose and remove | ||
the model of your machine. | ||
it. | ||
If it is composed of two pieces, press the tab | ||
• Clean any residues inside the filter as | ||
on the filter cap downwards and pull the piece | ||
well as fibers, if any, around the propeller | ||
out towards yourself. | ||
region. | ||
If it is composed of one piece, hold it from | ||
• If your product has a water jet feature, be | ||
both sides and open it by pulling out. | ||
sure to fit the filter into its housing in the | ||
| ||
| pump. Never force the filter while replacing | |
| it into its housing. Fit the filter fully into its | |
| housing; otherwise, water may leak from | |
| the filter cap. | |
| 4- Close the filter cap. | |
| Close the | |
3- An emergency drain hose is supplied with | by pushing the tab on it. | |
Close the | ||
some of our models. Others are not supplied | ||
by fitting the tabs on the bottom into their | ||
with this item. | ||
positions and pushing the upper part of it. | ||
If your product is supplied with an emergency | ||
| ||
drain hose, do the following as shown in the |
| |
figure below: |
|
•Pull out the pump outlet hose from its housing.
•Place a large container at the end of the hose. Drain the water off into the container
10- EN