For example, press and hold the “Start/Pause/ Cancel” button for 3 seconds in order to select “Cottons 40” program instead of “Cottons 60” program. Select the “Cottons 40” program.
Start the program.
Switching the machine to standby mode
Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the door.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the drawer. To do this;
1.Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine.
Child-proof lock
You can protect the appliance from being tampered by children by means of the child- proof lock. In this case, no change can be made in the running program.
The machine is switched to
CIf more than a normal amount of water and softener mixture starts to gather in the softener compartment, the siphon must be cleaned.
2.Wash the dispenser drawer and the siphon with plenty of lukewarm water in a washbasin.
3.Replace the drawer into its housing after cleaning. Check if the siphon is in its original location.
Ending the program through canceling
In order to cancel the selected program, press the “Start/Pause/Cancel” button for
3 seconds. You can select and start a new program when the “Ready” light is lit.
The “Spin” light illuminates if the cancellation process is activated in the middle of the program and the machine can either drain all the water or can take in water 3 times at most to cool down the clothes and perform the draining process.
The program which is selected first will keep on going even if the position of the program selection button is changed. A new program can be selected or started after “Program is cancelled” in order to change the washing program.
End of program
The “Ready” lamp on the program
Inlet water filters
There is a filter at the end of each water intake valve at the back side of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent the foreign substances and dirt in the water to enter into the machine. Filters should be cleaned as they get dirty.
•Close the taps.
•Remove the nuts of the water intake hoses to clean the surfaces of the filters on the water intake valves with an appropriate brush.
•If the filters are very dirty, you can pull them out by means of pliers and clean them.
•Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water.
•Replace the gaskets and filters carefully to their places and tighten the hose nuts by hand.
9 - EN