4
SETTING-UP THE MACHINE
▼Place the machine near to the connection points and ensure that it is level. To do this, adjust the feet by screwing or unscrewing them as required. When the machine is level, tighten the lock nuts on the feet using a spanner.
ELECTRICAL CONNECTION
▼Check that the power supply and socket are
correctly sized for the maximum load demand of your machine. The power supply voltage is indicated on the rating plate affixed to the filter door on the bottom right of the washing machine.
The mains electricity supply must be equipped with an earth. If this requirement is not complied with, the manufacturer will not be held liable for any resulting damage or injury.
WATER CONNECTION
▼Allow a good quantity of water to flow out of the system until it is clear and free of impurities, especially if the plant is new or has not been used for some time. Connect the water inlet pipe to the valve, inserting the filter/washer supplied. Check that the other end of the pipe is tightened properly. Position the drain hose between a minimum of 60 cm and a maximum 90 cm from floor level.
N.B. To prevent siphoning, do not make the machine drain hose connection air tight. If the water system is not provided with a drain, use the bracket supplied to position the drain pipe over a washbasin then tie it to a tap.
Do not use old or used fill hoses. Use only those supplied with the machine.
A |
|
MIN. |
|
MAX. 60 CM | |
90 | CM |
| |
GB