Beko WM 6123 S, WM 6103 W manual

No water can	This is not a problem. The
be seen in the	water level is not visible
machine during	from the outside of the
washing.	machine.
	Water level might be above	Run either the “Pump” or “Spin” program.
	the lower level of the door.
	Machine might be heating
	up the water or it may be at	Wait until the process is over.
The door is	the spinning cycle.
jammed.
	Due to electrical safety
	mechanism, the door can
	only be opened a few	Wait until the process is over.
	minutes after the program
	has stopped.
Machine fills
with water	Inside of machine may be	For safety reasons, water should be cycled in and
when a process	hot.	out a couple times.
is cancelled.
		The machine will wait until there is a sufficient
	Water pressure may be	amount of water, which may lengthen the
	low.	washing time to avoid poor washing results due to
		insufficient water.
	Supply voltage may be low.	Washing time is lengthened to avoid poor washing
		results when the supply voltage is low.
	Input temperature of water	Cycle time lengthens to heat up the water when
		the input water is cold. Also, washing time can be
	may be low.
Washing time		lengthened to avoid poor washing results.
takes longer		The automatic spin correction system might have
than the time
		been activated due to the unbalanced distribution
specified in the
		of the laundry in the drum.
manual
	There may be an imbalance	The laundry in the drum may be clustered (bundled
		laundry in a bag). Laundry should be rearranged
	of laundry in the machine.	and re-spun.
		No spinning is performed when the laundry is
		not evenly distributed in the drum to prevent any
		damage to the machine and to its environment.
	Number of rinses and/or	Water amount is increased to obtain a better rinse
	amount of rinse water might
		and a rinse cycle is added when necessary.
	have increased.

28

EN