Bosch Appliances LOGIXX 9 manual Fault displays, Cycle

Fault

Possible cause

Remedial action

Foam

comes

out

of

the

Too much

detergent.

Add 1

tbs. of

fabric softener￿litrtoe of water and

detergent

drawer.

pour into dispenserII.￿

Reduce the detergent dosage for the next wash

cycle.

Repeat

spin

cycle.

This is not a fault.

Always load largeand small items together into the

Unbalanced load detection system is attempting todrum.

compensate the imbalance by spinning the washing

several

times.

The

laundry

was

not

Large

laundry

items have become entangled and

Alwaysare load largeand small

items together

into the

spun.

not evenly distributed in the drum. For reasons ofdrum.

safety the high speed spin cycle was automatically

suppressed.

Programme

duration

This is not a fault.

Dispensing

the

correct

amount

of￿detergent

extended.

The foam detection feature has activated an

additional rinsing cycle to reduce the amount of

foam.

This is not a fault.

Always load largeand small items together into the

Unbalanced load detection system is attempting todrum.

compensate the imbalance by spinning the washing

several

times.

Poor

wash

result.

Soiling

is

greater

than expected.

Select

suitable

programme.

or

Intensive

Wash additional

option.

Detergent

underdosed.

Dose detergent according to the manufacturer's

instructions.

Detergent

residue

on

the

Some phosphate4free detergents contain

Brush

out

the

washing

after drying.

washing.

water4insoluble residues that may appear as light

spots

on

the

laundry.

Grey

residue

on

the

Soiling

caused

by

ointment, grease or oil.

Select maximum detergent dosage and maximum

washing.

permitted

temperature for

the

next wash

cycle.

Fault displays

Text on display panel Possible cause

Remedial action

Tap

closed?

Mains water tap is not opened.

Turn the tap on. Programme continues.

Inlet hose kinked or pinched.

Eliminate cause.

Filter blocked in water inlet hose.

Clean the strainer; see from Page￿26.

Water

pressure

too

low.

Eliminate cause.

•Pump

blocked?"

Drainage pipe and/or drainage hose blocked.

Clean drainage pipe and/or drainage hose.

•Door

open?"

Door

not

closed

properly.

Check whether laundry is trapped in door.

Close

the door.

If

the

fault

cannot

be

rectified

with the aid of the

above table:

switch off the appliance, wait 5￿seconds, t

the

appliance, select and

start

the programme.

If

the

fault

recurs,

call

Customer

Service, see Page

32.

30