7 Delay Start button
By pressing the DELAY START button, the start of a programme can be delayed by between 30 minutes (30') and a maximum of 20 hours (20h).
This option must be selected after having selected the programme and before pressing START/PAUSE to start the programme.
Every time the button is pressed, the time is increased by 30 minutes until the display shows a delay of 2 hours. After this, the delay is increased hour by hour.
If 20h is displayed and you press the button again, the time delay will be cancelled. The display will show 0' and then the duration of the selected programme.
To activate the count down, the START/PAUSE button has to be pressed. The amount of time remaining until the programme is set to start is continuously displayed (e.g. 12h, 11h, 10h, … 30' etc).
During the delayed start, it is not possible to change the programme or the delay time selected. To do this, you must first switch off the appliance by setting the programme selector to OFF.
If you wish to add more laundry while the countdown is running, simply open the door. When you close the door,
press the START/PAUSE button again to cause the count down to be resumed.
8 Display
The display shows the following information:
•duration of selected programme
•delayed start
•end of programme
•incorrect option selection
•alarm code
•Duration of selected programme
After you have selected the programme, its duration (in hours and minutes) appears on the display. It is calculated automatically on the basis of the maximum load being used for each type of fabric and of the required degree of drying.
it shows the duration of the previously selected programme. The countdown is displayed every 30 minutes until it displays “90 minutes” and then hour by hour.
3 
•End of programme
A flashing zero indicates the end of the programme and it is displayed after the
0
•Incorrect option selection
If you select an option that is not compatible with the programme you have selected, the display shows Err (error).
This code will reappear during the execution of the programme if you press one of the option buttons.
1.20
When the programme starts, the remaining time is displayed every 5 minutes.
•Delayed start
If you have selected a delay time by means of the
relevant button, the display shows it for 2 seconds; then 10
•Alarm code
In the case of a functional problem, the display shows an alarm code (e.g. E21). See page 18 for more detailed information.