C a r i n g f o r Y o u r D r y e r
Removing accumulated lint from inside the dryer cabinet (cont.)
7.Remove 2 internal screws from front panel flanges (near top front corners). Lift front panel slightly, lifting off lower clips (see lower clip inset of illustration below). Slowly pull front panel
forward, disengaging panel from drum. (Drum will drop slightly.)
8. Move front panel aside and rest edge against side of dryer. Avoid disconnecting wire clips (see wire clips inset of illustration below) or damaging wires.
9. Remove any lint using a vacuum cleaner or soft brush.
Burner | Motor |
(gas models only)
Dryer with front panel removed
10.Reassemble in reverse order. Before closing the top, check the following:
–Drum seal must be flared out (see drum seal insets of illustration) and properly positioned against panel at back of drum. Rotate drum counterclockwise one full turn to check drum seal.
–Belt should be centered and tight on dryer drum.
–Wire clip retainer, which holds the door switch wires, must be secured to top of front panel (see wire clips inset of illustration) and along top edge of side panel. Door wires must not touch drum when dryer is operating.
11.Replace top panel and lint screen screws. Top and front panels must be securely in place before operating dryer.
12.Level the dryer if necessary.
13.Plug in dryer or turn on power supply.
Drum |
|
Seal |
|
| Drum |
right | Seal |
| wrong |
side panel
front panel
OR
Wire clips
Lower clip
18