Majestic Appliances MJ9250W owner manual Safety, Pre-Installation

Page 9

SAFETY

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE

COVER (OR BACK). NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PROFESSIONALS.

The model number of this product may be found on the back of the unit; the serial number of the label affixed to the back of the unit.

You should note the model and serial numbers of this unit in the space provided. Retain this booklet as a permanent record of your purchase to aid in identification in the event of theft.

MODEL#

SERIAL#

INTRODUCTION

Your new appliance is carefully engineered product. Many times what appears to be a reason to call service, the problem may require nothing more than a simple adjustment you can easily make in your own home.

You will be charged for a service call while the appliance is in warranty if defective product workmanship or materials do not cause the problem covered by this warranty.

To avoid a charge for an unnecessary service call, and before calling a serviceman, please refer to the troubleshooting section for situations that you can remedy. This section is included on pages 20 of this Owners Manual.

Your Washer is front loading, with an extra large door opening for easier access. It has 8 wash cycles.

You will obviously want to obtain the best possible wash. By reading and following the instructions in this booklet you will achieve excellent results.

Please, ensure that the instructions are followed. If you should need any further advice or assistance, please, contact the dealer where your machine was purchased, or call Majestic Customer Service at 1-800-678-8002.

This appliance is an automatic washer with a capacity of up to:

WASH

14 Lbs

PRE-INSTALLATION

1.The unit must be installed on a strong level floor, and in protected, dry, and well-ventilated area close to a power and water supply of sufficient capacity, and a sufficient outlet.

2.Installation on Carpet or Wood increases vibrations.

Carpets - place on light carpet only.

Wood - brace floor with screws and place additional sheets of plywood before installation.

3.This unit’s installation and grounding should be done in accordance with local codes by a qualified installer. “Installation Instructions” are included in this manual for the Installer’s reference.

4.The unit should be plugged into a properly grounded three (3) prong electrical outlet of 110 V/ 60Hz with minimum 15 amps. It should not be controlled by a wall switch or pull cord which might be turned off accidentally.

8

Washer Owner’s Manual

Image 9
Contents MJ9250W Table of Contents Warranty Warranty InformationExclusions General Warranty ServiceEnergy Savings IntroductionYour safety and that of you children Important Safety InstructionsHelpful Hints PRE-INSTALLATION SafetyPicture of the Washer DoorInstallation UNPACKING, LEVELING, & PositioningElectrical Connection Connecting to the Water Faucet Connecting the Drain HoseGrounding RECESSED, Closet and Alcove Installation Instructions CB a Control PanelPower button Starting the Washer Operating InstructionsProgram Selection Chart Spin SpeedsUseful Tips Blood Stain Removal ChartGrass Winterizing Your WASHER/DRYER Understanding Fabric Care LabelsTechnical Data Maintenance The washer fails to start TroubleshootingCompany Information Service & Support