5. ADD FABRIC SOFTENER, if desired
Add the recommended amount to the cup in top of the agitator. The cup may be lifted out for easy filling. Add water to bring liquid level just below openings at the rim of the cup. Diluted fabric softener will
automatically be added to the final rinse. (Always dilute fabric softener with warm water.)
When using fabric softener, do not interrupt the spin following wash because the softener will go into the washbasket at the wrong time.
Periodically clean the cup with hot water and a soft brush or cloth.
6. Close the lid and you are ready to set the controls.
OPERATING THE WASHER CONTROLS
1. SELECT WATER LEVEL
Water level is selected by turning the load size selec-
for knob to the Small, Medium, or Large setting, Remember, for best washing results, clothes must cir- culate freely. If too little water is used, poor cleaning, linting and excessive wear may result,
NOTE: When laundering permanent press items,
delicates, washable woolens or loosely knit
items, never use less than the MEDIUM set-
ring. This will minimize shrinkage, wrin- kling and pulling of seams.
2.SELECT WATER TEMPERATURE
HOT--Wash water will be the temperature of the
water coming from the hot water faucet. Rinse water will be cold. Use this setting for heavily soiled whites and colorfast items. The water heater should be set to
a minimum of 120°F, with hotter water temps up to 140°F for best results.
will be cold. Use this setting for delicates, colored
items or permanent press garments with light to moderate soil.
NOTE: Water below 65°F is too cold to dissolve and activate granular detergents.
4