KitchenAid Washer Property Damage, Turn on waler faucets, Check that you have all

---

iin Carefully till washer backward Jnlil front of washer is 3-J inches off of lwr. Insert piece of wood as brace.

12 Use legs and ntis from pads n package. Screw nut down to

vithln l/2” of base.

13 n

nseri legs into :orrecl holes al lath front comer d washer until butstouch washer. )o not tiahlen nuis

Panel C

14 Tilt washer backward and H remove wood brace.

Genlly lower washer to floor.

Move washer to Its flnal locatlon. Remove cardboard or hardboard from under washer.

Slide washer onto cardboard or hardboard before moving across floor.

Failure lo do so may cause damage to floor covering.

adjust rear self-leveling legs. Gently lower washer lo floor. Check levelness o !he washer by placing a carpenlets level ,n top of the washer, firs1 side lo side; hen front lo back.

1

icrew Ihe front legs up or down lo adjust. Make final check with level.

Nhen washer is level, use Nrench to turn nuts on front leg! JP tightly against washer base. f nuts are not tight against w&y?; base, tha washer may

Property Damage

Secure the drain hose to the tub or standplpe with the shlpplng strap removed from the back of the washer.

Failure to properly secure drain hose could result In waler damage.

6

I

Nleasure and mark a poinf approximalely li 5 inches from Ihe plug end of the sllipping strap. Cul the shipping slrap al tt lis point.

C heck that hose Is not twlsted or kiInked and Is securely In place.

F‘ul “hook”end of drain hose in tub or

Slandpipe. Tightly wrap the shipping sfrap around the drain hose and tub or

Standpipe or inlet hose as shown in F‘igures A-C. Push plug into the nearest h018 in the shipping strap.

mD u

___---

Check that hose is not twisted or kinked and Is securely In place.

f drain hose cannot be strapped in place, I musl be cuf exaclly lo len$h so the ‘hook” end is held lightly over Ihe edge of he tub or standpipe.

Me: I, warher Is moved Loadjurt drain horn, lha vashsr mu., ba lavalad agaln. Rapea Slap* IS-

IS. Place cardboard under Lha washer and :arefully move washor lo avoid damaging floor :overing.

18 CHECK ELECTRICAL W REQUIREMENTS. BE

SURE YOU HAVE CORRECT :LECTRICAL SUPPLY AND 3ECOMMENDED GROUNDING

qCheck lhat all oarts are no’ nstalled. See parls list, Panel A. If the1 s an extra part, go back lhrough sleps I ,ee which slep was skipped.

Turn on waler faucets and

20q check for leaks. Tighlen ouplings if lhere is leaking.

Check that you have all of

qyour tools. Check that the lipping strapwith 3 colterpins and plug as removed from Ihe back of Ihe washc Id used lo secure Ihe drain hose.

22 Untape electrical cord and W plug into grounded oullet.

23 Take a few minules and q read Ihe Use and Care

Jide to fully understand your new isher. Now start the washer and allow complele the regular cycle.

To get the most efflclent use from your washer, read your KitchenAid Use and Care Guide. Keep Installation lnstrucllons and Guide close lo washer for easy reference.