Frigidaire FAQG7111LW-PKG, FAFS4073NA, FAFS4073NW, FAFS4073NR, 137502100A11122, STACKIT4X Water

Page 30

SOLUTIONS TO COMMON PROBLEMS

Service Prevention Checklist, continued

OCCURRENCE

POSSIBLE CAUSE

SOLUTION

 

 

 

WATER

 

 

Water collects in folds of

This is a result of the washing action and

 

the bellows at the end of

is part of the normal operation of the

 

the cycle.

washer.

 

 

 

 

Water collects in bleach

This is a result of the siphoning action

Water may be removed by removing the dispenser

and fabric softener com-

and is part of the normal operation of the

drawer (see Care and Cleaning in this guide) and draining

partments.

washer.

water into the empty drum or sink.

 

 

 

Wash load too wet after

Washer is overloaded.

Do not overload washer. See Operating Your Washer,

spin.

 

step 4.

 

 

 

 

Load is too small.

Add 1 or 2 similar items to help balance the load.

 

 

 

 

Load is out of balance.

Rearrange load to allow proper spinning.

 

 

 

 

Drain hose is kinked.

Straighten drain hose.

 

 

 

Water does not enter

Water supply is not adequate in area.

Check another faucet in the house. Wait until water supply

washer or it enters slowly.

 

and pressure increase.

 

 

 

 

Water supply faucets are not completely

Fully open hot and cold faucets.

 

open.

 

Water is being used elsewhere in the house. Water pressure must be at least 30 psi (260 kPa).

Avoid running water elsewhere while washer is filling.

Water inlet hoses are kinked.

Straighten hoses.

Warm or hot water is not hot enough.

Hot water heater is set too low or is a distance from washer.

Measure hot water temperature at nearby faucet with candy or meat thermometer. Water temperature should be at least 120°F (49°C). Adjust water heater as neces- sary.

Hot water is being used elsewhere in the house.

Avoid using hot water elsewhere before or during washer use. There may not be enough hot water avail- able for proper cleaning. If problem persists, your hot water system may be unable to support more than 1 use at a time.

Water in washer does not

Drain hose is kinked or clogged.

Clean and straighten the drain hose.

drain or drains slowly.

 

 

Drain hose standpipe is too tall. Maximum

Reduce standpipe height to less than 8’ (2.4 m). See

 

 

standpipe height is 8’ (2.4 m).

INSTALLATION INSTRUCTIONS.

 

 

 

 

House drain pipes are clogged.

Unclog drain pipes. Contact plumber if necessary.

 

 

 

Water leaks.

Fill hose connection is loose at faucet or

Check and tighten hose connections. Install rubber seal-

 

washer.

ing washers provided.

 

 

 

Oversudsing.

Wrong detergent.

Run rinse cycle. Use a low-sudsing, high efficiency

 

 

detergent.

 

 

 

 

Too much detergent.

Run rinse cycle. Use less detergent in future loads.

 

 

 

Incorrect wash and rinse

Hot and cold water hoses are connected

Connect hot water hose to hot water faucet and cold

temperatures.

to wrong supply faucets.

water hose to cold water faucet.

 

 

 

Water is entering washer

Drain hose standpipe is too low. Stand-

Increase standpipe height to at least 23.6” (60 cm). See

but tub does not fill.

pipe must be a minimum of 23.6” (60 cm)

INSTALLATION INSTRUCTIONS.

 

high to prevent siphoning.

 

 

 

 

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Use &Care Definitions Important Safety InstructionsRecognize safety symbols, words and labels Product RecordPrevent Fire Protect ChildrenPrevent Injury Prevent Injury and Damage to the ApplianceHarmful Vapor Hazard Features Operating Instructions Normal Operating SoundsOperating Your Washer Liquid Detergent For best resultsAdd laundry products to the dispenser Powder DetergentLiquid Chlorine Bleach Other Wash ProductsDetergent for Prewash Liquid Fabric SoftenerSelect the appropriate cycle and settings for the load Start the washerCycle Selection Rinse & spin on select models Spin only on select modelsSanitize Specialty Cycle Selection Spin Speed Cycle Settings For best resultsWash Water Temperature Soil LevelCycle Options Allergy on select modelsEnergy saver Clean washer Stain clean on select modelsDelay start Add steamOther Features Status DisplayWasher Settings Chart Operating Instructions Safe Stain Removal Procedures Stain Removal GuideFor Successful Stain Removal Stain Removal Suggestions Stain TreatmentTo Refresh or Clean Inside of Washer Care and CleaningInside Routine Cleaning Preventive Main Wash compartmentDaily Preventive Maintenance Inside Cleaning Aggressive Cleaning Procedure Washer DrumOutside Routine Cleaning Winterizing InstructionsSolutions to Common Problems Common Washing ProblemsSolutions to Common Problems Ately upon cycle completion Service Prevention Checklist Occurrence Possible Cause SolutionWater Major Appliance Warranty Information Warranty Periods

137502100A11122, FAFS4073NW, FAQG7111LW-PKG, FAQG7111LW, FAFS4073NA specifications

The Frigidaire FFHT2126LW is a versatile top-mount refrigerator designed to provide efficient storage and advanced cooling technology. With a capacity of 21.4 cubic feet, it offers ample space for groceries and beverages. The refrigerator features adjustable shelves that can be modified to accommodate taller items, while the humidity-controlled crisper drawers keep fruits and vegetables fresh for longer. Its Energy Star rating ensures that it operates efficiently, helping to reduce energy bills while being environmentally friendly.

The STACKIT4X is an innovative stacking kit engineered for the seamless installation of compatible washers and dryers. This convenient accessory maximizes laundry room space by allowing the dryer to be stacked on top of the washer, making it an ideal solution for smaller homes or apartments. The STACKIT4X features a sturdy design that ensures stability during operation and is compatible with various Frigidaire models, enhancing their overall functionality.

The FAFS4073NR and FAFS4073NA are part of Frigidaire's advanced front-load washer series. Both models boast a large capacity, which allows for more laundry to be washed in a single load. They incorporate technologies such as the Adaptive Design, which optimizes washing cycles based on load size and fabric type, leading to improved cleaning results. Energy efficiency is enhanced through features like the EcoConserve wash system, which utilizes less water and electricity while still delivering remarkable cleaning performance.

The FAQG7111LW is a front-load gas dryer that complements the aforementioned washing machines perfectly. It features various drying cycles tailored for different fabric types, ensuring that each garment is treated with care. The dryer also includes a moisture sensor that detects when clothes are dry, preventing over-drying and conserving energy. Its sleek design and easy-to-use controls make it an appealing addition to any laundry setup.

Together, these Frigidaire products embody a commitment to quality, efficiency, and convenience, making them suitable for modern households looking to enhance their kitchen and laundry spaces. With innovative technologies and user-friendly features, Frigidaire continues to be a leading choice for home appliances.
Top Page Image Contents