Frigidaire 137168200A important safety instructions Installed WASHer dimensions

Page 6

Installed WASHer dimensions

50.8” (129cm) to clear open door

29.75” (75.5cm)*

to front of closed door

water supply connection on rear of unit1

freestand washer on floor

floor line

washer mounted on optional pedestal

floor line

27.0”

(68.5cm)

 

drain hose

 

 

 

on rear

 

 

power cord

of unit3

 

 

 

 

 

on rear of unit2

 

51.25”

 

 

(130cm)

 

 

 

 

 

 

 

 

 

36.0”

 

 

(91.5cm)

 

 

 

 

 

 

 

 

 

 

 

 

 

*To obtain these minimal depth dimensions, dryer must be vented straight back. Using a quick-turn 90° elbow (right or down on freestanding dryer) adds approximately 0.75 in. (2.0 cm) to installation depth. Upward venting of exhaust on pedestal-mounted or freestanding dryer adds approximately 4 in. (10.2 cm) to installation depth. Leftward venting on pedestal-mounted or freestanding dryer adds approximately 3.75 in. (9.5 cm) to installation depth. Downward venting of exhaust on pedestal-mounted dryer adds approximately

2.25 in. (5.7 cm) to installation depth.

1Hot and cold inlet hose length approximately 43 inches (109cm) 2Power supply cord length approximately 60 inches (152.5cm).

3Drain hose length approximately 52 inches (132cm).

50.8” (129cm)

to clear open door

29.75” (75.5cm)*

to front of closed door

71.5”

(182cm)

water supply connection on rear of unit1

27.0”

(68.5cm)

electrical supply on rear of unit

gas supply pipe on rear of gas unit

37”

(94cm)

power cord

centerline height for rear vent

drain hose on rear of unit3

on rear of unit2

39”

(99cm)

*To obtain these minimal depth dimensions, dryer must be vented straight back. Using a quick-turn 90° elbow (right) adds approximately 0.75 in. (2 cm) to installation depth. Upward venting of exhaust on stacked dryer adds approximately 4 in. (10.2 cm) to installation depth. Downward venting of exhaust on stacked dryer adds approximately 2.25 in. (6.5 cm) to installation depth. Leftward venting of exhaust on stacked dryer adds approximately 3.75 in. (9.5 cm) to installation depth.

 

1Hot and cold inlet hose length approximately 43 inches (109cm)

 

2Power supply cord length approximately 60 inches (152.5cm).

6

3Drain hose length approximately 52 inches (132cm).

 

Image 6
Contents Installation Important Safety Instructions Installation ChecklistSuffocation Hazard Excessive Weight Hazard Note Fire HazardGround requirements Installation RequirementsElectrical system requirements Water supply requirementsInstallation in a Recess or Closet Do not Install Your WasherClearance requirements Installed WASHer dimensions Unpacking washer Removing foam packagingInstalling hole plugs NOTERemoving shipping hardware Leveling your washer Installation instructionsConnecting inlet water USE onlyConnecting drain and electrical Cable TIEACCESSOrIES Page Installation Liste de vérification d’installation Mesures de sécurité importantesAvertissement Risque D’INCENDIE  RemarqueRisque D’ÉTOUFFEMENT QUE Faire SI Vous Détectez UNE Odeur DE GAZExigences relatives à la mise à la terre Exigences d’installationExigences des systèmes électriques Exigences relatives à l’alimentation en eauInstallation dans un Endroit en Retrait ou une Armoire ’INSTALLEZ PAS Votre LaveuseExigences de dégagement Dimensions, appareil installé Déballage de la laveuse Retrait de l’emballage en mousseREMARQUE Retrait de la quincaillerie d’expéditionPose des bouchons Branchement de l’entrée d’eau Instructions d’installationMise à niveau de votre appareil UtilisezBranchement électrique et branchement du tuyau de vidange AttacheNécessaire DE Superposition DE Sécheuse AccessoiresSocle DE Rangement Assorti Nécessaire DE Rallonge DE Tuyau DE Vidange