JVC IKD-LH2000 manual To erase the entered characters, Select a character

Repeat steps 3 to 5 until you finish entering the name.

Assigning names to the sources	4 Select a character.
	• About the available
You can assign names to discs (both in this unit	characters, see page 47.
and in the CD changer), station frequencies and the
external component.
After assigning a name, it will appear on the display
when you select the source.

ENGLISH

Sources	Maximum number of
	characters
CDs*	up to 32 characters
	(up to 40 discs)
Station frequencies	up to 10 characters (up to
	30 station frequencies
	including both FM and AM.)
External component	up to 8 characters

*You cannot assign a name to a CD Text or an MP3 disc.

1 Select a source you want to assign a name to.

When you select a

source, the power automatically comes on.

2 Press and hold SEL (select) for more than 2 seconds while pressing DISP (D).

5 Move the cursor to the next

(or previous) character position.

6

7 Finish the procedure while the last selected character is flashing.

To erase the entered characters

Insert spaces using the same procedure

described above. (About the available characters, see page 47.)

Notes:

Ex.: When you select CD as the source

3 Select the character set you want while the first character position is flashing.

Each time you press the button, the character set changes as follows:

•When you try to assign a name to the 41st disc, you cannot enter the text entry mode (and will hear a beep sound if “Beep” has been set to “On”:see page 33.) In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to discs in the CD changer. These names can also be shown on the display if you insert the discs in this unit.

A – Z	a – z
(capital)	(small)

1 – 0 & Symbols

(numbers)

37