Philips HI478 Features, Before Using, For Dry Ironing, Filling the Removable Water Reservoir

Page 4

HI478/IRON.FA 1/13/00 2:35 PM Page 6

2

Features

Dual Language

Amber

Temperature

Pilot Light

Control Dial

3

Before Using

Remove any sticker or protective foil from soleplate

To ensure maximum steam performance,

•Clean any left over residue from the Steam Vents by following this procedure:

Red Auto-Off

Pilot Light

Variable Steam Control

Shot Of

Steam Button

Spray Button

Full Length

Button Groove

Self Clean

Button

• Drip Stop System

Automatically shuts off water

supply if iron is to cool to steam.

Removable

Water

Reservoir

Release Buttons

Fabric

Guide

Anti-Calc

Filter

Removable Water

Reservoir

Polished Optinox Soleplate

with Special 39-Vent Bell Pattern

ensures optimal and even steam

distribution

1Turn Steam Control to position 0.

2Fill iron (see section Filling the Removable Water Reservoir).

3Plug cord into electrical outlet. Set Temperature Control to maximum setting and allow iron to heat up for approximately 2 minutes.

4Turn Steam Control to position 3-4.

5Hold iron over ironing board and allow to steam for 1 minute, dislodging any residue.

6Iron over an old cotton towel (or other disposable non- synthetic cloth) for several minutes.

7Turn Steam Control to position 0 and Temperature Control to Min setting.

8Let iron cool. Clean Steam Vents.

9Iron is ready to use.

For Dry Ironing

1Plug cord into 120V AC outlet. Amber Pilot Light will glow.

2Always dry iron with Steam Control set at position 0 (Dry Setting).

3Be sure removable water reservoir is empty if you will be dry ironing for long periods of time.

4Preheat iron for approximately 2 minutes at proper temperature setting.

NOTE: Iron must be on heel rest to preheat. If left to preheat with soleplate in down position, iron will automatically shut off after 30 seconds before reaching desired temperature.

5Begin ironing. When finished, stand iron in upright position on heel rest. Remove cord from electrical outlet.

6Allow iron to cool completely before storing.

Filling the Removable Water Reservoir

Do not immerse the iron in water.

IMPORTANT:

When using your iron for the first time, you may notice a white deposit coming from the iron as it heats up.This is simply a residue left over from the final buffing of the iron soleplate. Follow the steps in “Before Using” to remove this residue.

1Unplug cord from electrical outlet.

2Set the Steam Control to position 0 (= no steam).

Image 4
Contents Iron Important Safeguards Read all instructions before usingDo not Attemptto Defeatthis Safety Feature Table of ContentsSpecial Instructions Save These Instructions Special Polarized Plug InstructionsFeatures Before UsingFor Dry Ironing Filling the Removable Water ReservoirSetting the temperature Other featuresSteam Ironing SprayingSelf-Cleaning Maintenance and StorageShot of Steam Anti-Calc FilterTo clean and maintain Polished Optinox soleplate Temperature and Fabric GuideTemp Steam Fabric Ironing Instructions Control Setting For assistance Full ONE YearwarrantyMade in Singapore