Using rinse and spin
NOTE: An Extra Rinse option is available in some cycles. See page 7.
When using extra detergent for heavily soiled clothes, or washing
1.To add an additional rinse, push in the Cycle Control Knob and turn clockwise to RINSE, as illustrated.
2.Pull out the Cycle Control Knob. The washer fills to selected load size, agitates, drains, and spins.
Using drain and spin
A drain and spin may help shorten drying times for some heavy fabrics or
1.Push in the Cycle Control Knob and turn clockwise to SPIN, as illustrated.
2.Pull out the Cycle Control Knob. The washer drains, then spins.
Understanding normal
Your new washer may make sounds that your old one didn’t. Because the sounds are unfamiliar, you may be concerned about them. Don’t be; most of them are normal.
The following describes some of the sounds you may hear and what causes them.
During washing
When you select a small load size setting for a small wash load, your washer has a lower water level. With this lower water level, you may hear a clicking sound from the upper portion of the agitator.
washer sounds
During drain
The rate that water is drained from your washer depends on your installation. If water is drained quickly from the washer, you may hear air being pulled through the pump. This happens during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear gears engaging.
9