Washing a Load of Laundry
Washing clothes manually
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1.Turn on the water at the water source sink.
2.Open the door.
3.Load the articles one at a time loosely into the drum, without overfilling.
4.Press the 
(On/Off) button on the washing machine.
5.Close the door.
6.Put the detergent and, if necessary, softener or prewash detergent, in the appropriate compartments.
7.Press the Temperature button to select the temperature (cold water, 30˚C, 40˚C, 60˚C, 95˚C).
8.Press the Spin button to select the spin speed, [no, rh, 400, 600, 800, …, no, … revolutions per minute(rpm)].
Note: The rinse hold program allows you to take clothes that are dripping wet out of the washing machine.
no : No Spin, rh : Rinse Hold.
9.Repeatedly press the Option button to select the cycle you prefer: Prewash (for Cotton, Synthetic, Delicate only)
10.Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1.Open the door.
Note: The door will not open until 3 minutes after the machine stops or the power turns off.
2.Remove laundry.
Using Delay Start
You can set the washing machine to start your wash automatically at a later time, choosing from a 1 to a 24 hour delay (in 1 hour increments).
To do this:
1.Manually or automatically set your washing machine for the type of clothes you are washing.
2.Press the Delay Start button repeatedly until the delay time is set.
3.Press the Start/Pause button. The Delay Start indicator will light, and the clock will begin counting down until it reaches your start time.
4.To cancel Delay Start, press the 
(On/Off) button, then turn the washing machine on again.
10 SAMSUNG Washing Machine Owner’s Instructions