Samsung WA70R3, WA80R3 user manual HOW to ADD the Fabric Softener, HOW to PUT the Detergent

Page 12

HOW TO ADD THE FABRIC SOFTENER

When a proper amount (one time does) of fabric softener is stored in the softener inlet, it is automatically put in at the last rinsing cycle.

Do not use detergent, bleach or starch into the Softener Inlet.

Using too much softener may produce unsatisfactory results.

Do not open the lid during the Spin Dry cycle. If

added too early, its effectiveness will decrease.

Do not leave the softener into the Softener. Dispenser for a long time. Because softner became stiff.

HOW TO PUT THE DETERGENT IN

1.Open the detergent box by pulling in the direction of the arrow as shown in the figure and then put the powder detergent in the detergent box.

2.Put in one-time amount of detergent evenly so the detergent may not brim over the box.

Detergent Device

Put the

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••

detergent in proportion

••••••••

••••••••••

 

 

to Water level

Softener Device

Softener baseline

CAUTION : If softener is stored over the above base line, it may flow down at any time.

WATER SUPPLY CONNECTOR FILTER

CLEANING THE FILTER

Clean the filter net often to keep the washer clean.

1. Push the upper part of the Magic 1. Push up and pull out the filter net. filter and pull in.

2.Open the cover as shown in the 2. Remove the collected lint from the

figure.

filter net.

3. Clean the Magic filter.

3. Clean the filter net.

4. Close the cover and insert the

4. Pull down the filter net.

lower part of the filter in the

 

basket first and then push the

 

filter with “click” sound.

 

HOW TO CLEAN THE PUMP FILTER

1.Pull out the filter and wash well.

inlet water valve

2.Pull in the filter and connect the hose to the inlet water valve tightly.

3.Check if there is a leakage.

Note to tighten up the connector.

1. Place a rag under the washer filter not to wet the floor.

2. Rotate the filter counterclockwise and pull out the filter.

3. Remove dirts and rotate the filter clockwise until it locks in position.

- 12 -

Image 12
Contents Troubleshooting Washing Machine WON’T Work Checking Before Washing and Caring for GarmentsFeatures Safety Instructions Description of Parts FilterLID Water Drain Hose Sound Absorption PanelChecking Before Washing and Caring for Garments Check if the clothes are bleaching or notTake out personal belongings from pockets Caring for Clothes Before WashingControl Panel Shake the dirt or soils from clothesFor protection of baby skin Turn inside out for those nappy clothes before washingBig volume laundry like blanket and bed cover sheets Special NotesDigital Course Blanket CourseUse for cleaner washing Washable sweater, cardigan, delicate clothes etcInstallation & Maintenance Manual FunctionsPlace the washer on a sturdy flat surface Avoid direct sunlight or heatersAdjustment the Height of the Machine Waterdrop Cause How to level MarkConnecting the Water Supply Hose HOW to Connect the Drain Hose HOW to Change the Drain Hose DirectionAssembling the RAT Protection Panel HOW to ADD the Fabric Softener HOW to PUT the DetergentWater Supply Connector Filter Cleaning the Filter HOW to Clean the Pump FilterTroubleshooting Washing Machine WON’T WORK?Washing Machine WON’T WORK? Continue