Samsung SW52ASP, SW62ASP Installation &MAINTENANCE, Environment, Case of PUMP-DRAINED Washer

Page 5

INSTALLATION &MAINTENANCE

ENVIRONMENT

Leave some space.

Maintain at least 10cm between the washer and the wall.

Place the washer on a sturdy flat surface.

If the washer is placed on an uneven or weak surface, noise or vibration occurs.

(allowable slope is 1 degree)

Never install the washer in a very steamy environment or where it might be open to the rain.

Excessive moisture may cause an electrical shock hazard.

IN CASE OF PUMP-DRAINED WASHER

Takeout the Be sure to join tightly

Install the drain

cap-hose and

the drain hose into the

hose in the position

connect the

drain-outlet on the left

of about 70~80cm

outlet-hose

side of the machine.

above the ground.

Avoid direct sunlight or heaters.

As plastic and electrical components are affected by direct heat,never place the washer near furnaces, boilers,etc.Do not place under direct sunlight.

HOW TO CONNECT WATER SUPPLY HOSE

Check the type of tap fitting which is in your laundry and then see appropriate instruction below:

A tap of ordinary type is desirable

In case of square tap

 

 

Takeout the internal part of the connector and join it in

 

 

 

the following way.

 

 

 

Internal part

ORDINARY TAP SQUARE TAP

ROTATING TAP

 

 

1. Remove the adaptor from the

 

 

4. Connect the water supply hose to

water supply hose.

 

 

the adaptor. Pull down the part (c)

 

 

 

of the water supply hose .

 

 

 

When you release part (c) the hose

 

 

c

is automatically connects to the

 

 

adaptor making a 'click' sound.

 

 

 

2. First,using a "+" type screw

 

 

5. Connect the other end of the water

driver, loosen the four screws on

 

 

supply hose to the inlet water valve

the adaptor.

 

 

at the top of the washer.

Next,take the adaptor and turn

a

 

Screw the hose clockwise all the

part(b) following the arrow for

b

 

way in.

gap about 5mm between them.

 

 

 

 

 

3. Connect adaptor to the water

 

 

6.If the water tap is a screw type,

tap by tightening the screws

 

 

assemble a water supply hose that

firmly.

 

 

fits to the tap as shown.

Then,turn part (b) following

 

 

 

the arrow and put (a) and

c

 

 

(b)together.

 

 

 

Note : The appliance is to be connected to the water mains using new hose-sets and that old hose-sets should not be used.

4

Image 5
Contents Cleaning the TUB Optional Cycle Troubleshooting SpecificationWashing Instruction Washing ProgramMagic Filter FeaturesDescriptionofparts Do not use this product for business purposes SafetyinstructionsHOW to Connect Water Supply Hose Installation &MAINTENANCEEnvironment Case of PUMP-DRAINED WasherHOW to PUT the Detergent Cleaning the Filter NETHOW to ADD the Fabric Softener When using an extension cord and a boosting transformer PrecautionsNever make an earthing to Outlet with earthing terminalsWash Program ProcedureWashinginstruction Econo Wash Program ※Keeping the tub clean Cleaning the TUBSensor Program Heavy Duty ProgramOptionalcycle Spin only Delay StartWash only Rinse only Soak Rinse and Spin onlyTroubleshooting