Samsung SW55USP Child-Lock, Function, Remaining Time, Delay Start, TIME, Error, Display

		This is a device to protect children from being accidentally hurt while playing
		with the washer.
		• How to start the Child-Lock function:
		- Press the “Power” button to go to an initial washing mode.
	CHILD-LOCK	- By pressing “Start/Hold” button, you start washing and in case Child Lock
9		function is needed during the laundry
	FUNCTION	- Press both the “Rinse” and “Spin” buttons at the same times.(for 3
		seconds) (Note: You cannot perform the function without the “Power”
		button on.)
		• To release the function of Child-Lock: In case the “Child-Lock” is
		programmed, press both the “Rinse” and “Spin” buttons at the same time.
10	REMAINING TIME,	Displays the remaining wash time.
	DELAY START	Displays the reserved delay start time.
	TIME, ERROR	Displays the error state if a problem occurs in the washing machine so that
	DISPLAY	you can take action.

Press this button to perform a soak wash.

11 SOAK BUTTON	This function cannot be selected during a Delicate course.
	Soaking is automatically applied during a Clean tub course.

You can set the soak time from between 10 to 60 minutes.

	MIST SHOWER	Press this button once to operate.
12		The mist dissolves laundry detergents more effectively leaving behind less
	BUTTON	residue.

Press this button to finish the wash at a specified time.

13 DELAY START Turn off your washing machine to cancel a reserved delay start.

BUTTON

You can set the delay start time from between 3 to 18 hours.

A course where silver water is supplied during the wash as well as during the last rinse, with sterilization and an antibacterial coating.

-Sanitization: Silver water is added to the water supply to perform an antibiotic sanitary wash. Sanitization is an antibiotic sanitary course. If only a hot water is selected, Silver wash cannot be selected.

14	SILVER WASH	- Bacteria protection: Silver water is supplied during the last rinse after the
	BUTTON	wash to apply an antibacterial coating to the laundry during the rinse.
		This is a sanitary rinse function to prevent the propagation of bacteria.
		- This is available for all courses except for the Delicate course.
		Using this function with fabric softener may reduce the effectiveness of
		this function.
		Press this button to fast dry your laundry.
15	AIR-TURBO	Each time the button is pressed, the selection changes in the following
		order.
	BUTTON
		30 Min  15 Min  Off  30 Min

This function can only be selected if a spin cycle is set.

	WATER LEVEL	The water level is automatically adjusted. However, you can select the water
16		level manually by pressing this button.
	BUTTON	Mid  High  Mid  Low  Extra low  Low  Mid

17WATER SUPPLY Each time this button is pressed, the type of water is selected as follows,

BUTTONCold  Cold & Hot  Hot  Cold

01 SettingETTINGupUPyourYOURwasherWASHER

Setting up your washer_11

SW55USPIW-02445K_EN(ÀÓ½Ã).indd 11

2009-05-28 ¿ÀÈÄ 4:28:48