|
| then 4 minutes later the F02 error code will be displayed. |
|
| Potential Causes |
|
| • Check the drain hose and make sure it is not plugged or |
|
| kinked |
|
| • Check the electrical connections at the pump and make |
|
| sure the pump is running. |
|
| • Check the drain pump filter for foreign objects |
|
| • If the above does not correct the problem replace the |
|
| pump |
|
|
|
F05 | Water temperature sensor error | If during the water heating step in the wash cycle, the |
|
| water temperature sensor (NTC) value is out of range, or |
|
| the heating element circuit has failed, the F05 error code |
|
| will be displayed. |
|
| Potential Causes |
|
| • Check the Water Temperature Sensor, Heating Element |
|
| and Element Relay |
|
| • Check connections to the Sensor, Heating Element and |
|
| Relay |
|
| Replace failed component. |
|
|
|
F06 | Drive motor tachometer error | The control is unable to properly detect motor speed and |
|
| the machine will shut down. If a failure occurs during |
|
| |
|
| minutes. |
|
| Potential Causes |
|
| • Check wire harness connections between the Drive |
|
| Motor/Tachometer and the Motor ControlUnit (MCU), and |
|
| between the MCU and the Central Control Unit (CCU) |
|
| • Check the Drive Motor |
|
| • Check the MCU |
|
| • Check the Wire Harness |
|
| Replace failed component. |
|
|
|
F07 | Motor control unit error | The Central Control Unit has detected a short in the |
|
| motor control unit. If a failure occurs during |
|
| spin the door will be unlocked after 3 minutes. |
|
| Potential Causes |
|
| • Check wire harness connections between the Drive |
|
| Motor and the Motor Control Unit (MCU), and between |
|
| the MCU and the Central Control Unit (CCU) |
|
| • Check the MCU |
|
| • Check the Drive Motor |
|
| • Check the Wire Harness |
|
| Replace failed component. |
|
|
|
F09 | Overflow condition | If the Overflow contact on the pressure switch is Closed |
|
| for more than 60 seconds an Overflow condition will |
|
| occur. In an Overflow condition, the Door will remain |
|
| locked, and the Drain Pump will run constantly, even if |
|
| PAUSE/CANCEL is pressed twice and the Display is |
|
| cleared. Unplug the unit to service. |
|
|
|