Indesit IWDE 126 manual Personalisations, Setting the temperature, Set the drying cycle, Functions

Personalisations

C Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 10).									GB
The temperature can be lowered, or even set to a cold wash (			).			The data contained in the
	Set the drying cycle		Table of drying times			table are purely indicative.
			Fabric	Load type	Max.
Turn the DRYING knob to set the desired drying type.
			type		load
Two options are available:					(kg)	Cup-	Hanger	Iron
						board
A - Based on time: From 40 minutes to 180.
B - Based on the damp level of the dry clothes:			Cotton,	Clothing of different sizes	5	180	170	140
			Linen
Iron	: slightly damp clothes, easy to iron.
Hanger : dry clothes to put away.			Cotton	Terry towels	5	180	170	140
Cupboard		: very dry clothes, recommended for towelling
			Terital,	Sheets, Shirts
and bathrobes.					2,5	140	120	100
			Cotton

A cooling stage is foreseen at the end of the drying cycle.
	Acrylics	Pyjamas, socks, etc.	1	70	65	60
If your laundry load to wash and dry is exceptionally in excess Nylon		Slips, tights, stockings, etc.	1	70	65	60
of the maximum load foreseen (see table opposite), perform

the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. Now follow the instructions provided for a dry only cycle. Repeat this procedure for the remainder of the load.

Dry only

Turn the PROGRAMME knob to one of the drying settings (7-8) depending on the type of fabric, then select the desired drying type using the DRYING knob.

Important: - A spin cycle is carried out during the drying if you have set a cotton programme and a level of dryness (Cupboard , Hanger , Iron ).

- For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics.

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.

Function	Effect	Comments			Enabled with
					programmes:
		Press the button repeatedly until the LED corresponding to the
	Delays the start	desired delay is turned on.			All
	of the wash by	The fifth time the button is pressed, the function will be disabled.
	up to 9 hours.	N.B.: Once you have pressed the Start/Reset button, the delay
Delay Timer		can only be decreased if you wish to modify it.
		When this function is set, programmes 4, 6 will end with the
	This option	laundry left to soak (Anti-crease) and the Rinse cycle phase
	reduces the	LED	will flash.		3, 4, 6,
	amount of	- to conclude the cycle, press the START/RESET button;
	creasing on	- to run the draining cycle alone, set the knob to the relative			9, 10,
	fabrics, making	symbol	and press the START/RESET button.		Rinse cycle.
	them easier to
	iron.	If you also want to run the drying cycle, this button is enabled
Easy iron		only if combined with level		(Iron).
	Increases the	Recommended when the appliance has a full load or with large			1, 2, 3, 4, 9,
	efficiency of the				10, 12, 13,
		quantities of detergent.
Extra Rinse	rinse.				Rinse cycle.
					All
	Reduces the				programmes
					except for 6,
	spin speed.
					7, 8 and
1200-600					draining.

11