Indesit IWDC 6143 instruction manual Indicator lights, Starting a wash cycle

Page 7

Indicator lights

The indicator lights provide important information. This is what they can tell you:

Delayed start

If the DELAY TIMER function has been activated (see “Personalisation”), after the wash cycle has been started the indicator light corresponding to the selected delay period will begin to flash:

As time passes, the remaining delay will be displayed and the corresponding indicator light will flash:

The set programme will start once the selected time delay has expired.

Wash cycle phase indicator lights

Once the desired wash cycle has been selected and has GB begun, the indicator lights switch on one by one to

indicate which phase of the cycle is currently in progress.

Wash

Rinse

Spin/Drain

Drying

End of wash cycle

Note: when the drying cycle has finished, the DRYING knob should be returned to the “0” position.

Function buttons and corresponding indicator lights When a function is selected, the corresponding indicator light will illuminate.

If the selected function is not compatible with the programmed wash cycle, the corresponding indicator light will flash and the function will not be activated. If the selected function is not compatible with another function which has been selected previously, the indicator light corresponding to the first function selected will flash and only the second function will be activated; the indicator light corresponding to the enabled option will remain lit.

Door locked indicator light

When the indicator light is on, the porthole door is locked to prevent it from being opened; make sure the indicator light is off before opening the door (wait approximately 3 minutes). To open the door during a running wash cycle, press the START/PAUSE button; the door may be opened once the DOOR LOCKED indicator light turns off.

￿Fast flashing of the "programme phases" and DOOR LOCKED indicator lights indicate an anomaly (see “Troubleshooting”).

Starting a wash cycle

1.Switch the washer-dryer on by pressing the ON/OFF button. All indicator lights will switch on for a few seconds, then they will switch off and the START/PAUSE indicator light will pulse.

2.Load the laundry and close the door.

3.Set the WASH CYCLE knob to the desired programme.

4.Set the washing temperature (see “Personalisation”).

5.Set the drying cycle if necessary (see “Personalisation”).

6.Measure out the detergent and washing additives (see “Detergents and laundry”).

7.Select the desired functions.

8.Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green.

To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle.

9.At the end of the wash cycle the indicator light will switch on. The door can be opened once the DOOR LOCKED indicator light turns off. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washer-dryer off by pressing the ON/OFF button.

7

Image 7
Contents WASHER-DRYER Instructions for useConnecting the electricity and water supplies InstallationUnpacking and levelling 65 100 cm Blue Neutral N Brown Live L Green & Yellow Earth E First wash cycleTechnical data Control panel Description of the washer-dryer and starting a wash cycleStarting a wash cycle Indicator lightsTable of wash cycles Wash cyclesFunctions Setting the temperatureSetting the drying cycle PersonalisationPreparing the laundry Detergents and laundryDetergent dispenser drawer Load balancing systemGeneral safety Precautions and tipsDisposal Care and maintenance Problem Possible causes / Solutions TroubleshootingService Guarantee Recycling & Disposal Information After Sales Service195079822.00 Essential Contact Information