Indesit IWDC 6105 Before using the appliance please read the instructions, Below, Service Depot

Page 3

Connecting the drain hose

• the supply voltage is included within the values indica-

GB

ted on the Technical Data Plate fixed on the machine;

 

65 - 100 cm

Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor;

• the socket is compatible with the washing

machine’s plug. If this is not the case, replace

the socket or the plug.

Your appliance is now supplied with a 13 amp fused plug

it can be plugged into a 13 amp socket for immediate use.

Before using the appliance please read the instructions

below.

WARNING - THIS APPLIANCE MUST BE EARTHED.

Where it connects to the waste water pipe cut end off spigot or remove the blanking cap

The drain hose may be connected to an under- sink trap. Before connec- ting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot.

If it is placed over the edge of a basin or sink be sure the free end of the hose should not be underwater.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED

OUT BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved

fuse to BS 1362 should always be used, and the fuse

cover re-fitted. If the fuse cover is lost, the plug must not

be used until a replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colour as indicated by the coloured marking or the

colour that is embossed in words on the base of the plug.

Replacements can be obtained directly from your nearest

Service Depot.

Removing the plug:

If your appliance has a non-rewireable moulded plug and

you should wish to re-route the mains cable through parti-

tions, units etc., please ensure that either:

the plug is replaced by a fused 13 ampere rewireable plug

bearing the BSI mark of approval.

or:

!We advise against the use of hose extensions; in case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.

Ensure that if the drain hose is pushed into a standpipe, that the end does not go down more than 15cms (6 in- ches). If the hose is pushed down too far, this may cause the machine to self -syphon ie. continuously empty as it is filling.

Electric connection

Before plugging the appliance into the mains socket, make sure that:

the socket is earthed and in compliance with the applicable law;

the socket is able to sustain the appliance’s maximum power load indicatedon the Technical Data Plate fixed on the machine;

the mains cable is wired directly into a 13 amp cable out-

let, controlled by a switch, (in compliance with BS 5733)

which is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make

the pins unusable so that it cannot be accidentally inserted

into a socket.

 

Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

Earth

Blue

Neutral

Brown

Live

3

Image 3
Contents WASHER-DRYER Instructions for useInstallation Connecting the electricity and water suppliesUnpacking and levelling If a replacement fuse cover is fitted, it must be Before using the appliance please read the instructionsBe used until a replacement is obtained Replacement fuse coversFirst wash cycle Technical data ON/OFF button Description of the washer-dryerStarting a wash cycle Control panelIndicator lights Remain lit Door locked indicator lightStarting a wash cycle Table of wash cycles Wash cyclesFunctions Setting the temperatureSetting the drying cycle PersonalisationPreparing the laundry Detergents and laundryDetergent dispenser drawer Load balancing systemThis appliance was designed for domestic use only Precautions and tipsGeneral safety DisposalCare and maintenance Problem Possible causes / Solutions TroubleshootingMachine wont spin properly Machine leaks from the dispenser Assistance Replacement of any removable parts made of glass or plasticRecycling & Disposal Information After Sales Service195073987.05 Essential Contact Information
Related manuals
Manual 16 pages 33 Kb