Indesit IWDE 7145 S manual Troubleshooting, Problem, Possible causes / Solutions

Page 13

Troubleshooting

Your Washer-dryer could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make

GB

sure that the problem cannot be not solved easily using the following list.

Problem:

The Washer-dryer does not switch on.

The wash cycle does not start.

The Washer-dryer does not take in water ("H2O" will flash on the display).

The Washer-dryer continuously takes in and

drains water.

The Washer-dryer does not drain or spin.

The Washer-dryer vibrates a lot during the spin cycle.

The Washer-dryer leaks.

The "option" indicator lights and the "start/pause" indicator light flash and an error code appears on the display (e.g.: F-01, F-..).

There is too much foam.

The washer-dryer does not dry.

Possible causes / Solutions:

The appliance is not plugged into the socket fully, or is not making contact.

There is no power in the house.

The Washer-dryer door is not closed properly.

The ON/OFF button has not been pressed.

The START/PAUSE button has not been pressed.

The water tap has not been opened.

A delayed start has been set.

The water inlet hose is not connected to the tap.

The hose is bent.

The water tap has not been opened.

There is no water supply in the house.

The pressure is too low.

The START/PAUSE button has not been pressed.

The drain hose is not fitted at a height between 65 and 100 cm from the floor (see “Installation”).

The free end of the hose is under water (see “Installation”).

The wall drainage system is not fitted with a breather pipe.

If the problem persists even after these checks, turn off the water tap, switch the appliance off and contact the Assistance Service. If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the Washer-dryer to fill with water and drain continuously. Special anti-draining valves are available in shops and help to avoid this inconvenience.

The wash cycle does not include draining: some wash cycles require the drain phase to be started manually.

The “Easy iron” option has been activated: To complete the wash cycle, press the START/PAUSE button (see “Wash cycles and options”).

The drain hose is bent (see “Installation”).

The drainage duct is clogged.

The drum was not unlocked correctly during installation (see “Installation”).

The Washer-dryer is not level (see “Installation”).

The Washer-dryer is trapped between cabinets and walls (see “Installation”).

The water inlet hose is not screwed on properly (see “Installation”).

The detergent dispenser drawer is blocked (for cleaning instructions, see “Care and maintenance”).

The drain hose is not fixed properly (see “Installation”).

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again.

If the problem persists, contact the Technical Assistance Service.

The detergent is not suitable for machine washing (it should display the text “for Washer-dryers” or “hand and machine wash”, or the like).

Too much detergent was used.

The appliance is not plugged into the socket, or not enough to make contact.

There has been a power failure.

The appliance door is not shut properly.

A delayed start has been set.

DRYING is in the OFF position.

13

Image 13
Contents WASHER-DRYER Instructions for useConnecting the electricity and water supplies InstallationUnpacking and levelling Green & Yellow Earth BlueNeutral Brown Live 65 100 cmBlue Neutral N Brown Live L Green & Yellow Earth E First wash cycleRegulation Technical dataDescription of the Washer-dryer Standby modeControl panel Display Door locked symbolSwitch the Machine ON. Press How to run a wash cycle or a drying cycleSetting the drying cycle Modifying the cycle settingsTable of wash cycles Wash cycles and optionsWash options Detergent dispenser drawer Detergents and laundryPreparing the laundry Special wash cyclesGeneral safety Precautions and tipsDisposal Opening the porthole door manuallyCare and maintenance Problem TroubleshootingPossible causes / Solutions Before calling for Assistance ServiceHave the following information to hand Months Parts and Labour Guarantee GuaranteeYear Parts Guarantee Republic of Ireland 01 230 Extended GuaranteesIndesit Service After Sales ServiceEssential Contact Information Recycling & Disposal Information