E1 Lint Screen, E1 Safety Door Switch | Sears 74291, 64291 guide

FEATURES

E1 Lint Screen

Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows:

!. With dryer off, remove the screen by pulling straight up.

2.Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove.

3.Replace the cleaned lint screen.

_Yir_!i_JlXe]

Fire Hazard.

Do not use your dryer while the lint screen is removed.

It could cause overheating and possible damage to fabrics and dryer parts or create a fire hazard. Lint screen must be pushed firmly into place.

NOTE: If lint screen gets clogged by detergent orfabric softener build-up, remove and clean it with a nylon brush, hot water and liquid detergent. Dry and replace screen.

E1 Safety Door Switch

For safety, the switch shuts off dryer when door is opened. Dryer will not

start until door is closed and START is pushed. Be sure the Cycle Selector

Control is on a dry setting.

[[3 Performance Guide Label

Located inside the dryer door. Gives information on what to do if dryer does not perform normally.

NOTE: If dryer drum is stained, clean it with a damp cloth and mild detergent.

l_l Model No. Plate

Shows model and serial numbers. Have these ready if you ever call for service.

Formore detailed drying times, rules for safe operation, fabric care, maintenance and installation information, refer to the LAUNDRY I GUIDE and INSTALLATION INSTRUCTIONS you rex_ived with

your dryer.

III

Part No. 3392338 Printed in U.S.A.