Samsung DC68-02347B-EN Electrical Conne Ctions, Replacement Parts and Accessories, Installation

Page 9

Installation Instructions

ELECTRICAL CONNE CTIONS

Before operating or testing, follow all grounding instructions in the Grounding section.

An individual branch (or separate) circuit serving only your dryer is recommended. DO NOT USE AN EXTENSION CORD.

A 120/240 volt, 60 Hz AC approved electrical service fused through a 30-ampere fuse or circuit breaker on both sides of the line is required.

The power cord should be plugged into a 30-ampere receptacle. NOTE: It is not permissible to convert a dryer in Canada to 208 volts.

REPLACEMENT PARTS AND ACCESSORIES

If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your dryer or the SAMSUNG customer care center at 1-800-SAMSUNG (726-7864).

INSTALLATION

Parts and literature are packaged inside your dryer drum. To install:

1.Move your dryer to an appropriate location for installation. Consider installing the dryer and washer side-by-side, to allow access to electrical, and exhaust connections.

Lay two of the carton cushion-tops on the floor. Tip your dryer on its side so it will lay across both cushion-tops.

2.Set your dryer back in an upright position.

3.Review the Exhausting section before installing the exhaust system. Install the ductwork from your dryer to the exhaust hood. The crimped end of the duct sections must point away from your dryer. DO NOT use sheet metal screws when assembling ducting. These joints should be taped.

Never use plastic flexible exhaust material.

Tip for tight installations: install a section of exhaust system to your dryer before putting it in place. Use duct tape to secure this section to your dryer, but do not cover louvers in dryer cabinet.

4.Review Electrical Requirements section.

BEFORE OPERATING OR TESTING, follow the grounding instructions in the Grounding section.

5.With a level, check your dryer and make necessary adjustments to the leveling legs.

6.At this time, make sure all exhaust and electrical connections are complete. Plug in your dryer, and check operation by using the checklist below.

FINAL INSTALLATION CHECKLIST

Dryer is plugged into electrical outlet and properly grounded.

Exhaust ductwork is hooked up and joints taped.

Plastic flexible duct is NOT used.

Use rigid or stiff-walled flexible metal vent material.

Dryer is level with all legs firmly on the floor.

Start your dryer to confirm that it runs, heats, and shuts off.

SAMSUNG Dryer Owner’s Instructions A-5

Image 9
Contents Electric Dryer What you need to know about Safety Instructions Safety PrecautionsRecognize Safety SYMBOLS, WORDS, Labels What to do if YOU Smell GASSafety Precautions Table of Contents Installation Instructions Tools needed for installationSee Exhaust Requirements 10 .16 cm 6.35 cm Ducting RequirementsImportant to Installer Alcove or Closet InstallationLocation Considerations Exhausting Mobile Home InstallationElectrical Requirements GroundingInstallation Replacement Parts and AccessoriesFinal Installation Checklist Electrical Conne CtionsDon’t let a poor exhaust system slow drying by Dryer Exhaust TipsDoor Reversal Overview of the Control Panel Operating Instructions, TipsDigital Graphic Display Start/Pause Selection Button MY Cycle Child LockRack Dry Installing the Drying RackClean the Lint Filter Load the Dryer ProperlyGetting Started Care and Cleaning Things to Avoid Special Laundry TipsCheck These Points if Your Dryer TroubleshootingInformation Codes Code Meaning SolutionAppendix Fabric Care ChartProtecting the Environment SpecificationDeclaration of Conformity DivCycle Chart Samsung Dryer Limited Warranty to Original Purchaser Samsung To obtain warranty service, please contact Samsung atMemo