vi. Fitting your appliance into your
kitchen...
Inserting the machine into the cabinet:-
-Push the machine into the opening, aligning it with the cabinets (Fig.8).
-Regulate the adjustable feet to raise the machine to the appropriate height.
-To adjust the position of the wooden panel in both the vertical and horizontal directions, use the C and D screws, as shown in Fig.9.
Important: Close the lower part of the appliance front by ensuring that the plinth rests against the
floor.
Fig. 8 | Fig. 9 |
Remember you may be charged for a service call if a problem with your appliance is caused by incorrect installation or misuse.
Move the appliance into position, care must be taken that the Water Supply pipes and the Drainage hose are not kinked or trapped.
Direct the mains cable towards the electrical socket to be used but DO NOT plug in at this stage.
There must be at least 2mm clearance at the sides and top of the appliance. The back of the appliance must also remain some distance away from the back wall. If the recessing cavity is higher than 820mm, the opening between the floor and sides of the appliance (when installed at the end of a line of furniture) must be completely closed in.
10