Electrolux EWG12740-W user manual Hinges, Mounting the door, Counter-magnet

b) Hinges

To mount the hinges it is necessary to drill two holes (dia. 35 mm, depth

12.5-14 mm depending on the depth of door furniture) on the inner side of the door. The distance between the holes hobs fixing centres must be 416 mm.

The distance (B) from upper edge of the door to the centre of the hole depends on the adjacent furniture's dimensions.

The required dimensions are given in the picture C.

The hinges will be fixed to the door by means of screws for wood (2-Fig. B) supplied with the appliance.

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The hinges can be adjusted to com- pensate for possible uneven thickness of the door.

To align the door perfectly it is neces- sary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see pic- ture D).

installation	electrolux	39
6
4
P0984	D

If the door has to be opened from left to right, invert the position of the plates (7), the magnet (4) and the plate (5) (Fig. B and E). Mount the countermag- net (6) and the hinges (1) as previously described.

			E
4			6
	5	7	1
		3
P0983			2

Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised.

Where the appliance has been raised by mounting onto a wooden base pro- vided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.